KOLINK Stronghold Prime Midi Tower Case User Manual
- June 2, 2024
- KOLINK
Table of Contents
KOLINK Stronghold Prime Midi Tower Case
ACCESSORY PACK CONTENTS
PANEL REMOVAL
- Left Panel – Unscrew the 4 thumbscrews and lift off carefully.
- Right Panel – Unscrew the two thumbscrews and slide off.
- Front Panel – Find the bottom cutout, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release.
MOTHERBOARD INSTALLATION
- Align your motherboard with the chassis to locate where the stand-offs should be installed.
- Once done, remove the motherboard and fasten stand-offs accordingly.
- Insert your motherboard 1/0 plate into the cutout at the rear of the case.
- Place your motherboard into the chassis, making sure the rear ports fit into the 1/0 plate.
- Use the provided motherboard screws to attach your motherboard to the chassis.
POWER SUPPLY INSTALLATION
- Place the PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure them with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
VIDEO CARD/PCI-E CARD INSTALLATION
- Carefully position and side your care into place, thing on the slot size of your card) secure with the add-on card screws supplied.
2.5″ SSD INSTALLATION (FRONT)
Align your SSD with the holes next to the motherboard plate and secure it from
behind with screws.
3.5″ HDD/2.5″ SSD INSTALLATION
Allen the 3.5 HDD/2.5 SSD with the screw holes on the PSU shroud or on the
bottom of the chassis and secure with screws.
TOP FAN INSTALLATION
Align your fan(s) to the screw holes on the top of the chassis and secure with
screws.
FRONT/REAR FAN INSTALLATION
Align your fan to the screw holes on the chassis and secure with screws.
WATERCOOLING RADIATOR INSTALLATION
Secure the fans to the radiator, then fasten the radiator inside the chassis
by securing it with screws from the outside.
1/0 PANEL INSTALLATION
- Carefully check the labelling of each connector from the 1/0 panel to identify its function.
- Cross-reference with the motherboard manual to locate where each wire should be installed, then secure one at a time.
- Please ensure they are installed in the correct polarity to avoid non-function or damage.