CAMPINGAZ 1 Feu R R80 Single Gas Cylinder Burner Instruction Manual

June 3, 2024
CAMPINGAZ

CAMPINGAZ - logo

1 Feu R R80 Single Gas Cylinder Burner
Instruction Manual

1 Feu R R80 Single Gas Cylinder Burner

CAMPINGAZ 1 Feu R R80 Single Gas Cylinder Burner - fig| CAMPINGAZ 1 Feu R R80 Single Gas Cylinder Burner -
fig1
---|---
CAMPINGAZ 1 Feu R R80 Single Gas Cylinder Burner -
fig2| CAMPINGAZ 1 Feu R R80 Single Gas
Cylinder Burner - fig3

InstructIons for use

Note: unless otherwise specified, following generic terms “appliance / unit /product / equipment / device” appeared in this instruction manual all refer to the product “1 feu  r”.
Consumption: 99 g/h (1,35 kW) – injector n° 015556
Category: direct butane pressure.
Thank you for having chosen this Campingaz®
A – IMPortAnt: You Are usInG GAs, tAKe GreAt cAre !

The purpose of these directions for use is to enable you to use your Campingaz® “1 FEU R” appliance properly and in complete safety. Please read them carefully, so as to  familiarise yourself with the appliance before assembling it onto its gas container.
Please follow the instructions that appear in these directions for use. Any failure to follow these instructions may pose a danger both to the user and to people in the vicinity.  Always keep these directions for use in a safe place so that you can refer to them if need be. this appliance must only be used with campingaz ® cylinders 901, 904 and 907. It  may be dangerous to use any other gas containers.
La societe Application Des Gaz will not accept any liability in the event that a cylinder manufactured by any other brand is used. this equipment should only be used outside  premises and kept away from inflammable materials.
Do not use an appliance that is leaking, not working properly or damaged. return it to the shop you bought it from, which will give you details of the nearest after-sales  service outlet.
Never modify this appliance or use it for applications for which it is not intended.

PUTTING THE APPLIANCE INTO SERVICE FITTING TO CAMPINGAZ CYLINDERS 901.

904 and 907

(If an empty cylinder is in place, read section : “Removing or changing the cylinder”) When inserting or removing a cylinder, always do so in an airy location, preferably  outside and never close to a naked flame, heat source or spark (cigarette, electrical appliance, etc.), and well away from any other people and inflammable materials.

  1. C heck that the stove seal and the tap thread (see fig.1) are in place and in good condition.
  2. Do not use the stove if the seal is missing or damaged: return it to your stockist.
  3. Check that the gas valve is properly closed by turning the wheel clockwise (“-” direction indicated by the arrow) (Fig.1).
  4. Remove the plug from the cylinder.
  5. Screw the stove on the valve of the cylinder (Fig.2).

The stove is ready to operate.
In the event of leakage (smell of gas prior to turning the tap on), take the equipment outside immediately, in a well-ventilated area with no combustion source, where the leak  can be located and halted. If you wish to check that your equipment is correctly sealed, do so outside. Never attempt to locate leaks using a flame. Use gas leak solution.

USE

  1. Additional advice:
    Do not use your stove less than 20 cm from a wall or a combustible object.
    Place the equipment on a horizontal surface and avoid moving it during use to prevent the appearance of large flames due to the combustion of liquid butane instead of  vaporised butane.
    If this occurs, put down the equipment and extinguish it by closing the gas valve.
    In the event of a leak (smell of gas), close the gas valve.

  2. Lighting
    – Hold a flame near the burner, then gradually open the gas by turning the wheel anticlockwise (“+” direction indicated by the arrow) (Fig.3).
    – When cooking food, always adjust the flame to the size of the pan used and whenever possible cover the pan with a lid to save energy.
    – For outdoor use, it is recommended to use the CAMPINGAZ® windshield sold as an accessory (Fig 5).

  3. Extinguishing
    – Close the gas valve

  4. Removing or changing the cylinder
    The cylinder can be removed even if it is not empty.
    – Close the valve and make sure that the burner is extinguished.
    – Unscrew the stove and check that the seal is in place and in good condition before screwing the stove back on a full cylinder in accordance with the instructions in  “Fitting to CAMPINGAZ ® cylinder”.

STORAGE-MAINTENANCE

After complete cooling of your stove:

  • Disconnect the cylinder as indicated in “Removing or changing the cylinder”.
  • Place the stove and the cylinder in a cool, dry and well-ventilated place out of the reach of children, and never in a basement or a cellar.
  • If the injector is clogged (the cylinder still contains gas but the stove does not light), do not attempt to unclog it with an instrument (needle, wire, etc.). Use only the  CAMPINGAZ ® unclogging device available at specialized CAMPINGAZ ® points of sale.
  • To unclog it, close the valve, completely unscrew the burner and insert  the unclogging device in the hole in the injector (Fig. 4).
    Accessory available in shops: 1 FEU windshield.

CAMPINGAZ - logoAPPLIcAtIon Des GAZ
219, Route de Brignais – BP 55
69563 Saint Genis Laval – France
075641 (ECN20065991-03)

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals