KOLINK Stronghold Prism ARGB Midi Tower Case User Manual
- May 15, 2024
- KOLINK
Table of Contents
- ACCESSORY PACK CONTENTS
- PANEL REMOVAL
- MOTHERBOARD INSTALLATION
- POWER SUPPLY INSTALLATION
- GRAPHICS CARD/PCI-E CARD INSTALLATION
- 2.5″ SDD INSTALLATION (R)
- 3.5″ HDD INSTALLATION
- TOP FAN INSTALLATION
- FRONT/REAR FAN INSTALLATION
- WATERCOOLING RADIATOR INSTALLATION
- References
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
STRONGHOLD PRISM
ARGB MIDI TOWER CASE
USER MANUAL
ACCESSORY PACK CONTENTS
PANEL REMOVAL
PANEL REMOVAL
- Left Panel – Pull the tab to open the hinged glass panel and lift off the hinges
- Right Panel – Unscrew the two thumbscrews and slide off.
- Front Panel – Find the bottom cut out, stabilise the chassis with one hand, and pull from the cutout with a little force until the clips release
- Top Panel – Locate the lip at the back of the panel and pull firmly up and away, stabilising the chassis with your other hand.
|
---|---
MOTHERBOARD INSTALLATION
MOTHERBOARD INSTALLATION
-
Align your motherboard with the chassis to locate where the stand-offs should be installed.
Once done, remove the motherboard and fasten stand-offs accordingly. -
Insert your motherboard I/O plate into the cutout at the rear of the case.
-
Place your motherboard into the chassis, making sure the rear ports fit into the I/O plate.
-
Use the provided motherboard screws to attach your motherboard to the chassis.
POWER SUPPLY INSTALLATION
POWER SUPPLY INSTALLATION
- Place PSU in the bottom rear of the case, within the PSU shroud.
- Align the holes and secure with screws.
GRAPHICS CARD/PCI-E CARD INSTALLATION
VIDEO CARD/PCI-E CARD INSTALLATION
- Remove the rear PCI-E slot covers as necessary (depending on the slot size of your card)
- Carefully position and slide your PCI-E card into place, then secure with the add-on card screws supplied.
2.5″ SDD INSTALLATION (R)
2.5″ SSD INSTALLATION (REAR)
- Remove the bracket from the rear of the motherboard plate, attach your 2.5″ drives and then screw back into place.
2.5″ SSD INSTALLATION (REAR)
- Place the 2.5″ HDD/SSD into/on top of the HDD bracket and screw in if required.
3.5″ HDD INSTALLATION
3.5″ HDD INSTALLATION
- Place the 3.5″ HDD into/on top of the HDD bracket and screw in if requir
TOP FAN INSTALLATION
TOP FAN INSTALLATION
- Remove the dust filter from the top of the case.
- Align your fan(s) to the screw holes on the top of the chassis and secure with screws.
- Replace your dust filter once secured.
FRONT/REAR FAN INSTALLATION
FRONT/REAR FAN INSTALLATION
- Align your fan to the screw holes on the chassis and secure with screws.
WATERCOOLING RADIATOR INSTALLATION
WATERCOOLING RADIATOR INSTALLATION
- Secure the fans to the radiator, then fasten the radiator inside the chassis by securing with screws from the outside.
Pro Gamersware GmbH
Gaußstraße 1, 10589 Berlin, Deutschland
info@gamersware.com
+49(0)30 83797272
www.kolink.eu |
support@kolink.eu
The WEEE symbol indicates that this product must not be disposed of with normal household waste. Through the correct disposal of this product, you will help protect the environment. For more information on the disposal of this product, please contact your local municipality, your waste disposal service or the shop where you purchased the product.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>