magnima 2AXZF Air Point Ring wireless wearable mouse User Manual

2AXZF Air Point Ring wireless wearable mouse
User Manual

INTRODUCTION

AirPoint® Ring is a finger wearable computer mouse that can be used to wirelessly control a computer or mobile device. The AirPoint® Ring supports both 2D and 3D motion, and it can be used as an air mouse or surface mouse. The included AirPoint® charger can be used to charge and store the AirPoint® Ring when it is not being used.
Package contents

• AirPoint® Ring
• AirPoint® charger
• Charging cable (USB-C)
• Finger size adapters: small, medium, and large
• Quick start guide
• AirPoint® Manual

Supported devices
The AirPoint® Ring can be used with the following operating systems:

The AirPoint® Ring can also be used with the following mobile operating systems with limited functionality (no software):

Safety considerations
This product contains small parts that could be a choking hazard. Keep it and all parts out of the reach of children.
Do not attempt repairs on this product yourself.
Prolonged computer use is associated with several medical conditions, including, but not limited to, muscle soreness and fatigue, repetitive stress injury, vision problems, headache, and obesity. Keeping your head straight with a computer screen at eye level, taking regular breaks, and limiting computer use and exercise will help reduce many of these problems. Seek professional medical help if any of these conditions occur.
CAUTION
Do not disassemble or remodel the product.

CONTROLS

PAIRING THE AIRPORT RING

1. Slide the AirPoint® Ring power switch to On.
   The green LED will glow.

2. Open the list of available Bluetooth devices on your device.

3. Find AirPrint in the list and connect.
   The green LED will stop glowing when the AirPoint® Ring pairs with your device.

The green LED will glow when the AirPoint® Ring is disconnected from a device.

WEARING THE AIRPORT RING

The three sizing adapters can be used to adjust the size to fit your finger. To use the adapter, slide it into the inside of the Ring and make sure it’s locked properly.

Wear the AirPoint® Ring on your index finger.

USING AN AIRPORT RING ON A SURFACE

finger button over the item you want to drag and move the AirPoint® Ring.
Scroll| Press and hold the lower touchpad with your thumb or press and hold the finger button over the scroll bar and move the AirPoint® Ring up or down.

USING AN AIRPORT RING AS AN AIR MOUSE

Activate or deactivate
air mouse mode| Tap the upper or lower touchpad with your middle finger.
---|---
Left-click| Tap the lower touchpad with your thumb or press the finger button.
Right-click| Tap the upper touchpad with your thumb.

The AirPoint® Ring will automatically enter sleep mode after 60 seconds of inactivity. Move the AirPoint® Ring to wake it.
The speed of the cursor movement can be adjusted from the system settings of the PC:

Pointer options > set the pointer speed by sliding

AIR SLIDE

In presentations, to navigate to the next slide, deactivate air mouse mode and tilt the thumb in a clockwise direction as shown in the figure. Likewise, to move to the previous slide, tilt the thumb in a counter-clockwise direction as shown in the figure.
In macOS, the direction of slide change will be opposite by default.
To change the slide direction: System Preferences->Mouse->Uncheck the Scroll Direction

OPTIMIZE AIRPOINT RING USING AIRPORT APPLICATION

The Windows and macOS AirPoint® application can be downloaded from www.magnima.com/product/airpoint-ring Install the application to explore more of AirPoint® Ring.
The additional features of AirPoint® Ring namely ‘Left-hand mode’, ‘Presentation mode’, and ‘Air mouse sensitivity adjustment’ can be activated through the ‘AirPoint®’ desktop application. There will also be indications on the app for a firmware or software update.
The AirPoint® application can be used with the following operating systems:
The AirPoint® application can be used with the following operating systems:

LEFT-HAND MODE

To activate/deactivate Left-Hand mode, single click on the left-hand mode icon on the app as shown in the image below.

NOTE: When AirPoint® Ring is in left-hand mode, it is designed to be worn on the left-hand index finger

PRESENTATION MODE

To activate/deactivate Presentation mode, single click on the presentation mode icon as shown in the image below.

Go to the next slide| Tap the lower touchpad with your thumb or press the finger button
---|---
Go to the previous slide| Tap the upper touchpad with your thumb.

AIR MOUSE SENSITIVITY ADJUSTMENT

To adjust the Air Mouse sensitivity, use the slider in the app as shown in the image below and set the range by sliding.

UPDATING THE AIRPOINTS RING FIRMWARE

The AirPoint® Ring firmware can be updated using the AirPoint® application. When the AirPoint® Ringfirmware is being updated, the LED will first glow yellow and green together and then yellow and red together. The LED will glow green when the firmware update is complete and the AirPoint® Ring is ready to use.

KILL MODE

Kill mode is a quick way to prevent unwanted movement by disabling the AirPoint® Ring.
To activate or deactivate kill mode, simultaneously press for three seconds the finger button and the upper touchpad of the air mouse mode activation pads.
The LED will blink twice indicating kill mode activation/deactivation.

TROUBLESHOOTING

No cursor movement with the device after prolonged usage in the Mac system

1. Make sure the AirPoint® Ring is turned ON
2. Verify that AirPoint® Ring is in a ‘connected’ state in the Bluetooth list of the host device
3. If the device is in a ‘connected’ state and no pointer movement then remove the device from the Bluetooth device list and connect again.

Please visit magnima.com for detailed troubleshooting steps.
You can contact customer support at 1-800-694-4815 or contact@magnima.com.

CLEANING

Use a dry cloth or apply a small amount of cleaner to the cloth to clean the AirPoint® Ring. The AirPoint® Ring is not waterproof, and it should not be cleaned with water or sprayed directly with cleaner.

CHARGING

To charge the AirPoint® Ring, dock the ring to the AirPoint® charger. The LED will change to yellow when the power is low and red when the power is extremely low.

To charge the AirPoint® charger, connect the AirPoint® charger to a power supply using a USB-C cable. The LEDs on the AirPoint® charger will light up one by one to indicate the charging progress.

SPECIFICATIONS

Dimensions| AirPoint® Ring: 36mm x 32mm x 39mm
AirPoint® charger: 65mm x 66mm x 68mm
---|---
Weight| AirPoint® Ring: < 50 grams
AirPoint® charger: 150 grams
Package: 360 grams
Battery life| 8-10 hours after fully charged
Battery capacity| AirPoint® Ring: 65 mAh
AirPoint® charger: 750 mAh
Sensors| ● 3D Accelerometer
● Gyroscope
● LED Optical Sensor
● Tactile Switches
● Capacitive Touchpad
Wireless connection| Bluetooth 5.0
Wireless operating range| 100 ft (40m) average

WARRANTY

1-year limited hardware warranty.
FCC compliance statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and meets applicable limits for radio frequency (RF) exposure. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CAUTION: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Patent information

Disclaimer
Every effort has been made so that the instructions and information in this guide are accurate and complete. Liability cannot be given for any omissions or errors.
Do Not Disassemble Or Remodel The Product.
Magnum reserves the right to make any changes without notice to this or any other product of the company.

WWW.MAGNIMA.COM
© Copyright Magma
FCC ID: 2AXZF-APR1050

References

• Wearable Mouse Ring | Magnima | Technology and Consulting
• Wearable Mouse Ring | Magnima | Technology and Consulting
• AirPoint Ring Wireless Mouse Control | Magnima

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>