RCN DTA-ES DTA Remote Control User Manual

Table of Contents

RCN-DTA-ES-DTA-Remote-Control-
PRODUCT

Locale the manufacturer’s code for
Turn on your TV
Depress the SET key for three seabeds until the LED IMuminales. Release the key;
Enere tS manutacuers ooe rom ne aO0e isLneLEDUMS
Very the V can be controlled by depressing the TV power key he TV time of, um
If the TV cannot be a controlled property. return o Step 1 and enter the nedd code from the list You may have to perform this operation numerous times until correct operation of the VIS is achieved.
the above steps do not identify a code to operate the TV, perform the Code Search Frograng Moo.

Code Search Programming Method:

if the code has been found by the Code Search Programming Method, the code that operates the TV can be identified as follows:

Depress the SET key for three seconds until the LED illuminates. Release the key
Press the Info” key. The LED will tum of
Press “1” to obtain the first digit; The LED will fash as many times as the number of the 1s digit
Press 2 to obtain a 2d digit The LED will tash as many times as the number of the 2 digit
Press 3 o obtain 3 digits The LED will fash as many times as the number of the 3 digits.
Press the “SET key to exit code recall mode. LED will 1ash twice.

NOTE: the number is “0 the LED will flash 10 times.

Restoring remote to factory settings

Depress the “SET” key for three seconds until the LED illuminates. Release the key
Depress and release in order the, “8 and “1 key – LED flashes twice to signal
remote reset
NOTE: Whenever a programming sequence exceeds 5 seconds, the remote will default to the previous settings.

RCN-DTA-ES-DTA-Remote-
Control-1

Read User Manual Online (PDF format)