ResMed 33963 Tubing Wrap User Guide

: June 6, 2024
: ResMed

Table of Contents

User Instructions
Fitting
Cleaning instructions
Disposal
Symbols
Documents / Resources

ResMed 33963 Tubing Wrap

User Instructions

The tubing wrap is intended to reduce condensation and temperature loss in ResMed air tubing when connected to a device.
The tubing wrap is available in two variants, Standard (33963) and SlimLine (36811), referred to collectively as `tubing wrap’ throughout this manual.

Code| Colour| Length|

Diameter

---|---|---|---

33963

| Blue| 6’6” (2 m)| 0.75” (19 mm)
36811| Grey| 6’ (1.8 m)|

0.6” (15 mm

Fitting

Fully unzip the tubing wrap and unfasten the VelcroTM strap.
Lay the tubing wrap down with the inside facing up.
Pass one end of the air tubing through the closed zipper end of the tubing wrap until the rubber cuff is through.
Hold the rubber cuff in position, then zip up the tubing wrap.
Fold the extended end of the zipper back against the tubing wrap and secure using the Velcro strap. Only the rubber cuffs should now be visible.

Note: If you have a Standard tubing wrap and you want to use it with SlimLine air tubing, you must complete this additional step between steps 3 and 4:

At the open end of the tubing wrap, fold the extra length over by approximately 6” (15 cm) and secure using the Velcro.

WARNING
Do not use the tubing wrap if the room temperature is above 86°F (30°C). At higher temperatures the air temperature at the mask may be too hot.

Note: For any serious incidents that occur in relation to this device, these should be reported to ResMed and the competent authority in your country

Cleaning instructions

The tubing wrap should be hand washed or dry cleaned only. Wash the tubing wrap separately when new, as the colour may run. Do not bleach.
To wash the tubing wrap:

Wash in cold to warm water using a mild detergent.
Rinse well and drip dry.

Note: Hand washing your tubing wrap does not replace the need to clean your air tubing.

Disposal

The tubing wrap and packaging does not contain any hazardous substances and may be disposed of with your normal household refuse.

Symbols

The following symbols may appear on your tubing wrap or packaging.

| Warning
---|---
| Consult instructions for use
| Manufacturer
| European Authorized Representative
| Catalogue Number
| Batch Code
| Importer
| Medical device

See symbols glossary atwww.resmed.com/symbols

Global leaders in sleep and respiratory medicine[ www.resmed.com](http://www.resmed.com)

Manufacturer: ResMed Pty Ltd 1 Elizabeth Macarthur Drive Bella Vista NSW 2153 Australia.
See ResMed.com for other ResMed locations worldwide. For patent information, see ResMed.com/ip.
Velcro is a trademark of Velcro Industries B.V. © 2020 ResMed. 3681089/2 2020-11

Documents / Resources

| ResMed 33963 Tubing Wrap [pdf] User Guide
33963, Tubing Wrap
---|---
| ResMed 33963 Tubing Wrap [pdf] Instructions
33963 Tubing Wrap, 33963, Tubing Wrap, Wrap