LUMOS LHEUT-A0 Remote Lite User Guide

June 5, 2024
Lumos

LUMOS - logo

User Guide

LHEUT-A0 Remote Lite

Lumos Remote Lite User Guide
Remote Lite is a remote control meant to control the turn signals on Lumos products.
Setting Up and Usage Instructions

  1. Place the remote on the handlebar, somewhere close enough to your hands such that they can be easily accessible during your ride.
  2. Secure the remote to your handlebar using one of the 4 silicone rubber bands provided.
  3. To pair remote with helmet, put helmet in pairing mode, and hold down L and R buttons until blinking, then press L or R to complete the pairing.
  4. To blink the left turn signal, press L. To blink the right turn signal, press R.

FCC-Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV  technician for help.
Remote Model: Lumos Remote Lite
Remote Model Number: LRELTN-A0
Transmission Power: 0 dBm
Voltage: 3.0V

Lumos Ultra User Guide
Before using your Lumos Ultra, review the user guide at Lumoshelmet.co/manual/ultra
Safety and Handling
See “Safety, handling, and support” in the Lumos Ultra User Guide.

Lumos One-Year Limited Warranty

Lumos warrants all products sold by Lumos to be free of defects in material and workmanship for a period of one (1) year from the date of purchase unless otherwise specified on the product. If a product is found to be defective by Lumos, in its sole discretion, Lumos’ only responsibility will be to replace or repair the defective product. Lumos will not be responsible for any costs, losses, or damages incurred because of the loss or use of any of its products, and Lumos specifically disclaims all claims for consequential and incidental damages. This limited warranty is subject to several important restrictions:
This limited warranty only applies to products purchased directly from Lumos. If purchased from a Lumos Authorized Reseller, please contact them directly. This limited warranty is valid only for the original purchaser of a product, and it cannot be transferred to another person upon the sale, lease, or transfer of the product. This limited warranty does not cover normal wear and tear.
This limited warranty does not apply to anything other than defects in the manufacturing and workmanship of the product.
The limited warranty is waived if you seek to repair the product using anything other than approved Lumos products and services, or if you seek to combine the product with any third-party product (like sealants, cameras, or custom helmet pads).
If upon its inspection, Lumos discovers that you have modified, changed, or altered the product in any way, this limited warranty is waived.
Lumos gives no warranty regarding the life of the batteries used in its products. Actual battery life may vary depending on a number of factors, including, but not limited to, the configuration and usage of a product. Your use of our products is at your own discretion and risk. You will be solely responsible for (and Lumos disclaims) any and all loss, liability or damages resulting from your use of our products, including loss of life, personal injury, or the loss of or damage to the computer, mobile device, and all other property. Lumos does not guarantee or promise any specific level of performance or battery life associated with the use of its products or any feature of them. All warranties implied by state law, including the implied warranties of merchantability and fitness for a particular purpose, are hereby limited to the duration of the limited warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. With the exception of any warranties implied by state law as hereby limited, the foregoing limited warranty is exclusive and in lieu of all other warranties, guarantees, agreements, and similar obligations of the manufacturer or seller.
FCC-Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of the FC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

RF Warning-Statement

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction. This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

  1. This device may not cause interference, and (
  2. This device must accept any interference, including interference that may cause undesired operation of the device.

Remote Model: Lumos Remote Lite
Remote Model Number: LRELTBK1 N-A0

Fitting Instructions
The helmet must fit properly to be effective. With a proper fit, the helmet will not move back and forth or side to side while fastened. The helmet can only protect if it fits well. Refer to the following image

LUMOS LHEUT A0 Remote Lite

Usage Warnings
Warning: No helmet can protect the wearer against all possible impacts.
Warning: This helmet can only protect if it fits well and the buyer should try different sizes and choose the size which feels secure and comfortable on the head.
Warning: The helmet is designed to be retained by a strap under the lower jaw. The straps are positioned so that they do not cover the ears, the buckle positioned away from the jawbone, and the straps and buckle adjusted to be both comfortable and firm.
Warning: To be effective, a helmet must fit and be worn correctly. To check for correct fit, place helmet on head and make any adjustments indicated. Securely fasten retention system. Grasp the helmet and try to rotate it to the front and rear. A correctly fitted helmet should be comfortable and should not move forward to obscure vision or rearward to expose the forehead.
Warning: No attachments should be made to the helmet except those recommended by the helmet manufacturer
Warning: The helmet is designed to absorb shock by partial destruction of the shell and liner. This damage may not be visible. Therefore, if subjected to a severe blow, the helmet should be destroyed and replaced even if it appears undamaged. Warning: The helmet may be damaged and rendered ineffective by petroleum and petroleum products, cleaning agents, paints, adhesives, and the like, without the damage being visible to the user.
Warning: A helmet has a limited lifespan in use and should be replaced when it shows obvious signs of wear.
Warning: This helmet should not be used by children while climbing or doing other activities where there is a risk of hanging or strangulation if the child gets trapped whilst wearing the helmet.
Warning: It is dangerous to modify the helmet’s original components
EU Declaration of Conformity
Hereby, Lumos Helmet declares that the radio equipment type Lumos Ultra helmet is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.Lumoshelmet.co/EU_DoC_ultra
Helmet Model: Lumos Ultra
Helmet Model number: LHEUT-A0 I LHEUT-M0 C.P.S.C. 16 CFR Part 1203 (Consumer Product Safety Commission) United States Federal Safety Standard for Bicycle Helmets CE, EN1078:2012 +A1:2012
F1447-18 For use in recreational bicycling but not trick bicycling or downhill mountain bike racing or roller hockey
Patent Pending
This helmet is designed to protect against impact caused by the collision of the head with an obstacle while cycling and roller-skating, it has passed EN1078:2012+A1:2012 to show conformity to the EHSR of Regulations (EU) 2016/425. EU Type examination conducted by: SGS Fimko Oy, Takomotie 8, FI-00380 Helsinki, Finland. Notified Body No: 0598 AS/NZS 2063:2008 Australian New Zealand Standard Bicycle Helmets

Company Information
21st Floor, CMA Building
64 Connaught Road, Central
Hong Kong

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Lumos User Manuals

Related Manuals