Furbo Mini Dog Camera User Guide
- June 5, 2024
- Furbo
Table of Contents
Mini Dog Camera
User Guide
Setting Up Your Furbo Mini
-
Plug in your Furbo Mini
-
Proceed to the Furbo app once you see a blinking yellow light
-
Select “+” in the Furbo app to add a new device and follow the onscreen setup instructions.
Status Indicator
Placing Your Furbo Mini
Place or mount your Furbo Mini 
To mount to the wall:
- Clean surface before mounting
- Remove the back paper and press Furbo Mini firmly against the wall for 30 seconds
To remove:
Use dental floss to remove the adhesive pad from the surface.
FCC
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
For products available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator & your body.
ISED
This device contains license-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science, and Economic Development Canada’s license-exempt
RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
This radio transmitter [IC: 22715-MINICAM] has been approved by Innovation, Science, and Economic Development Canada to operate with the antenna types listed below, with the maximum permissible gain indicated. Antenna types not included in this list that have a gain greater than the maximum gain indicated for any type listed are strictly prohibited from use with this device.
| Antenna Type | Model Number | Antenna Gain(dBi) | Remark |
|---|---|---|---|
| Dipole | ALX20E-051AA2-00 | 3. | 2.4G and BT |
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment.
This equipment should be installed and operated with a minimum distance of
20cm between the radiator & your body.
The transmitter module may not be co-located with any other transmitter or
antenna.
CAN ICES-3 (B)/NMB-3(B)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>