motorola MH011 Boom3 Bluetooth Headset User Manual

June 5, 2024
Motorola

motorola MH011 Boom3 Bluetooth Headset

AT A GLANCE

the important bits, quick and easy

CHARGE IT

let’s get you up and running
To charge your headset, plug the Type C cable into the headset’s Type C port and connect to Type C power source.

Note: Fully charge the headset before you use it.

Tip: To save battery power, turn off the headset when you’re not using it.

Caution: Your battery is designed to last the life of your device. It should only be removed by a recycling facility. Any attempt to remove or replace your battery will damage the device, void your warranty, and could cause injury.

CONNECT & GO

let’s get you connected

EASYPAIRTM METHOD

COMFORT

what feels best on you

Choose your most comfortable fit ear tip.

BASICS

standard features, advanced quality

To…|
---|---
answer a call| short press MFB.
reject a call| press volume down 2 seconds.
end a call| short press MFB
on| boom open( on)
off| boom close( off)
change call volume| press the volume up and volume down button
mute or unmute a call| press volume down 2 seconds during the call and press volume up 2s to unmute.
last track| press volume down 2 seconds when headset is in music state.
next track| press volume up 2 seconds
pause/play| press MFB once to pause and press again to play.
pairing mode| press MFB 5 seconds to enter into pairing mode when headset is in on mode.
reset| press MFB and volume down 5 seconds.
3-way call ongoing
pick incoming call, put ongoing call on hold.| press MFB once
reject incoming, continue ongoing| press and hold volume down
end ongoing, resume waiting call| double press MFB
switch calls| press MFB once
end current call| double press MFB

Notes:

  • Some features are phone/network dependent.
  • Using a mobile device or accessory while driving may cause distraction and may be illegal. Always obey the laws and drive safely.

STATUS LIGHT

If light shows… your headset is…
power on blue flashes 1 second.
power off red flashes 2 seconds.
pairing red & blue flashes alternately.
on standby blue flashes once every 5 seconds.
charging steady red.
fully-charged steady blue.
low battery red flashes once every 5 seconds.

Notes:
After one minute on a call or 20 minutes of inactivity, the light stops flashing to conserve power, but the headset remains on. Closing the Boom also saves battery life.

ADVANCED

more clever stuff

SECOND DEVICE

Do you use two phones? Or maybe a phone and a tablet? Connect with both of them.

  1. Pair the first device with your headset as normal (see “CONNECT & GO” on page 4).
  2. Turn off the Bluetooth® feature on the first device.
  3. Now pair the second device with your headset as normal.
  4. Once paired, to connect with both devices simply turn them on.

SETTINGS

Restore Factory Settings:
Reset default factory settings on your headset.

Caution:
This feature erases all device pairing information stored on the headset.

Multipoint:
Connect your headset to two devices.

Safety instructions for use

To avoid hearing damage, keep the volume at a moderate level. Avoid listening to music at loud volume levels for prolonged periods of time as this may cause permanent hearing damage or hearing loss. Your hearing is delicate and highly sensitive so please listen to your music responsibly. For more information visit the Deafness Research Foundation www.drf.org.

Don’t use Boom 3 when it is unsafe to do so. For example, while operating a vehicle, cycling, crossing a road, or any activity which requires your attention and ability to hear.

You should be aware of your surroundings and use Boom 3 responsibly.

Help & more

Note: If you’re watching video while using your earbuds, your audio may be slightly out of sync with your video.

Manufactured, distributed, or sold by Binatone Electronics International LTD., official licensee for this product. MOTOROLA and the Stylized M Logo are trademarks or registered trademarks of Motorola Trademark Holdings, LLC. and are used under license. Apple logo is a trademark of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc. Google Play and Android are trademarks of Google Inc. All other trademarks are the property of their respective owners. © 2020 Motorola Mobility LLC. All rights reserved.

Product ID: MH011
FCC ID: VLJ-MH011
IC: 4522A-MH011

General Information

Consumer Products and Accessories Limited Warranty (“Warranty”)
Thank you for purchasing this Motorola branded product manufactured under license by Binatone Electronics International LTD (“BINATONE”).
What Does this Warranty Cover?
Subject to the exclusions contained below, BINATONE warrants that this Motorola branded product (“Product”) or certified accessory (“Accessory”) sold for use with this product that it manufactured to be free from defects in materials and workmanship under normal consumer usage for the period outlined below. This Warranty is your exclusive warranty and is not transferable.
Who is covered?
This Warranty extends only to the first consumer purchaser, and is not transferable.
What will BINATONE do?
BINATONE or its authorized distributor at its option and within a commercially reasonable time, will at no charge repair or replace any Products or Accessories that does not conform to this Warranty. We may use functionally equivalent reconditioned/ refurbished/ pre-owned or new Products, Accessories or parts.

What Other Limitations Are There?
ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED TO THE DURATION OF THIS LIMITED WARRANTY, OTHERWISE THE REPAIR OR REPLACEMENT PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER, AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. IN NO EVENT. SHALL MOTOROLA OR BINATONE BE LIABLE, WHETHER IN CONTRACT OR TORT (INCLUDING NEGLIGENCE) FOR DAMAGES IN EXCESS OF THE PURCHASE PRICE OF THE PRODUCT OR ACCESSORY, OR FOR ANY INDIRECT, INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OF ANY KIND, OR LOSS OF REVENUE OR PROFITS, LOSS OF BUSINESS, LOSS OF INFORMATION OR OTHER FINANCIAL LOSS ARISING OUT OF OR IN CONNECTION WITH THE ABILITY OR INABILITY TO USE THE PRODUCTS OR ACCESSORIES TO THE FULL EXTENT THESE DAMAGES MAY BE DISCLAIMED BY LAW. Some jurisdictions do not allow the limitation or exclusion of incidental or consequential damages, or limitation on the length of an implied warranty, so the above limitations or exclusions may not apply to you.
This Warranty gives you specific legal rights, and you may also have other rights that vary from one jurisdiction to another.

Consumer Products| One (1) year from the date of the products Products original purchase by the first consumer purchaser of the product
---|---
Consumer Accessories| Ninety (90) days from the date of the Accessories accessories origina l purchase by the first consumer purchaser of the product
Consumer Accessories that are Repaired or Replaced| The balance of the original warranty or for Ninety (90) days from the date returned to the consumer, whichever is longer.

Normal Wear and Tear. Periodic maintenance, repair and replacement of parts due to normal wear and tear are excluded from coverage.
Batteries. Only batteries whose fully charged capacity fal ls below 80% of their rated capacity and batteries that leak are covered by this Warranty.
Abuse & Misuse. Defects or damage that result from: (a) improper operation, storage, misuse or abuse, accident or neglect, such as physical damage (cracks, scratches, etc.) to the surface of the product resulting from misuse; (b) contact w ith liquid, water, rain, extreme humidity or heavy perspiration, sand, dirt or the like, extreme heat, or food; (c) use of the Products or Accessories for commercial purposes or subjecting the Product or Accessory to abnormal usage or conditions; or (d) other acts which are not the fault of MOTOROLA or BINATONE, are excluded from coverage.
Use of Non-Motorola branded Products and Accessories.
Defects or damage that result from the use of Non-Motorola branded or certified Products or Accessories or other peripheral equipment are excluded from coverage.
Unauthorized Service or Modification. Defects or damages resulting from service, testing, adjustment, installation, maintenance, alteration, or modification in any way by someone other than MOTOROLA, BINATONE or its authorized service centers, are excluded from coverage.
Altered Products. Products or Accessories with (a) serial numbers or date tags that have been removed, altered or obliterated; (b) broken seals or that show evidence of tampering; (c) mismatched board serial numbers; or (d) nonconforming or non-Motorola branded housings, or parts, are excluded from coverage. Communication Services. Defects, damages, or the failure of Products or Accessories due to any communication service or signal you may subscribe to or use with the Products or Accessories is excluded from coverage.
You will receive instructions on how to ship the Products or Accessories at your expense and risk, to a BINATONE Authorized Repair Center. To obtain service, you must include: (a) the Product or Accessory; (b) the original proof of purchase (receipt) which includes the date, place and seller of the Product;(c) if a warranty card was included in your box, a completed warranty card showing the serial number of the Product; (d) a written description of the problem; and, most importantly; (e) your address and telephone number.

Disposal of the Device (environment)
At the end of the product life cycle, you should not dispose of this product with normal household waste. Take this product to a collection point for the recycling of electrical and electronic equipment. The symbol on the product, user’s guide and/or box indicates this. — Some of the product materials can be re used if you take them to a recycling point. By reusing some parts or raw materials from used products you make an important  contribution to the protection of the environment. Please contact your local authorities in case you need more information on the collection points in your area. European Union Directives Conformance Statement
The following CE compliance information is applicable to Motorola products that carry one of the following CE marks:

Hereby, Binatone declares that this product is in compliance with:

FCC Notice to Users
The following statement applies to all products that bear the FCC logo and/or FCC ID on the product label.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. See 47 CFR Sec. 15.lOS(b). These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can  radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and the receiver.
  • Connect the equipment to an outlet on a circu it dierent from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation. See 47 CFR Sec. 15.19(a)(3). Motorola has not approved any changes or medications to this device by the user. Any changes or medications could void the user’s authority to operate the equipment. See 47 CFR Sec. 15.21.

Industry Canada Notice to Users

This device contains licence-exempt transmitter( s) /receiver( s) that comply with Innovation, Science and Economic Development Canada’ s licenceexempt RSS( s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the device.

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals