GRANBERG SIZE 7/S Bundle Superflex Gloves Instructions
- July 17, 2024
- GRANBERG
Table of Contents
Instructions
SIZE 7/S Bundle Superflex Gloves
ART. 108.0560
12 pairs CAT. I
SIZE 7/S (EN ISO 21420:2020)
EN ISO 21420:2020
This product is classed as Category I Personal Protective Equipment (PPE)
according to PPE Regulation (EU) 2016/425 and has been shown to comply with
this Regulation through the Harmonised Standard EN ISO 21420:2020.
Declaration of Conformity can be obtained from
https://www.granberg.no/catalog/108.0560
| Glove size | S | M |
|---|---|---|
| EN ISO 21420 size | 7 | 8 |
Wear the products of suitable sizes to provide optimal level of protection and maximum grip. User must only choose the glove fitting the size of her/his hand.
STANDARD
100
21.HNO.59941
Hohenstein HTTI
www.oeko-tex.com
User Manual issue date: 20.02.2024
Granberg AS, Bjoavegen 1442, NO-5584 Bjoa, NORWAY
Gardening glove, liner made of nylon with grey foam latex coating.
Soft, flexible and comfortable. Good grip and high touch sensitivity.
Storage/Transport: The gloves are first packed in plastic bags which are
subsequently packed in cardboard boxes for transport and storage. Granberg
recommends storing unused gloves in original packaging. Prevent direct
sunlight.
Maintenance/Cleaning: Both new and used gloves should be inspected before use, and before putting them on to make sure that there is no damage to them. If in doubt, discard the gloves and select a new pair. Leaving the gloves in a contaminated condition may cause a deterioration of quality. Cleaning or disinfecting the gloves may also negatively affect quality. The performance characteristics of gloves that have been worn or cleaned/disinfected/laundered may differ from the performance levels declared.
Obsolescence: When stored as recommended, unused gloves will not suffer any change in their mechanical properties for up to three years from the date of manufacture. Service life depends on application and maintenance and cannot be specified. It is the responsibility of the user to ascertain the suitability of the gloves for the user’s tasks.
Donning/Doffing: Select the right size glove for your hand. Hold the glove by the cuff with one hand. Align the glove thumb with your other hand thumb and slide your hand into the glove, one finger into each finger. Pull by the glove cuff and align fingers into the right position. Use the same procedure for the other hand. If gloves are not contaminated, pull by the fingertips to doff the gloves. If gloves are contaminated, hold the glove cuff and pull toward the finger until the gloves come off.
Please note: Inspect the gloves for damage before use.
The gloves shall not be worn when there is a risk of entanglement with moving
parts of machines. Gloves meeting the requirement for resistance to puncture
may not be suitable for protection against sharply pointed objects such as
hypodermic needles. Gloves containing latex may cause allergic reactions in
case of hypersensitivity to latex. Seek medical advice if applicable. None of
the raw materials used in glove, or process of manufacturing it, are known to
be harmful to the user. These gloves are intended to protect hands in working
environments in accordance with EN . It is the responsibility of the ISO
21420:2020 user to evaluate and determine risks based on the intended
application. The gloves should only be used for applications declared suitable
by the manufacturer. Risk should be evaluated keeping in mind the protection
levels and the harmonized standards on which gloves are tested. The results of
the tests should help in glove selection, however it must be understood that
actual conditions of use cannot be simulated and it is the responsibility of
the user, not the manufacturer, to determine glove suitability to the intended
use. Further information may be obtained from manufacturer.