FOSTER KT001 WH 01 Wireless Headphones User Manual

June 5, 2024
FOSTER

Foster

FOSTER KT001 WH 01 Wireless Headphones

FOSTER-KT001-WH-01-Wireless-Headphones

Product Overview

FOSTER-KT001-WH-01-Wireless-
Headphones-1

Specification Remarks

  • Not supported any use case of connecting with general smartphones.
  • Pairing mode is locked when PDL is fully registered.

Hardware Information

Topic Value
Product type Bluetooth® Headphone

For dedicated RSI unit

Chipset| QCC3004
LED| RGB LED x1 (function)

Red LED x1 (charging)


Button

| 4 buttons Power

Volume Up/Down

Channel Select (CS)

MIC| MEMS x1 *1
USB| USB type-C

Software Information

Topic Value
ADK ADK QCC300x 1.0.167
Bluetooth® version Bluetooth® 5.0
Support profiles A2DP v1.3.1 AVRCP v1.6

HFP v1.7

Support codecs| SBC
Multipoint| No
Pairing PIN| 0000
PDL size| 2 devices
BT Device Name| KT001 WH 01
BT VID source| USB Implementers Forum
BT Vendor ID| 0x0230
BT Product ID| 0x0012

*1. Always muted without factory test mode.

UI – Button operation

UI Event User Action
Power on Long press [PWR]
Power off VLong press [PWR]
Enter pairing mode *1 Hold [PWR] after power on
Channel Switch Short press [CS]
Volume up Short press [Vol +] / Hold [Vol +]
Volume down Short press [Vol -] / Hold [Vol -]
Factory Reset (Clear PDL) ****

VVLong press [PWR] & [CS] at power off

Enter Maintenance mode| ****

VVLong press [PWR] & [Vol +] at power off


(Enter DUT mode)

| VLong press [CS] & [Vol +] in maintenance mode


(Enter BCCMD mode)

| VLong press [PWR] & [Vol -] in maintenance mode

Button Duration

UI Event User Action
Short Press Press and release within 800ms
Long Press Press and hold for 1.0 sec long

Very Long Press

| Press and hold for 2.0 sec long

(In Factory Test Mode, 1.5 sec long)

Very Very Long Press| Press and hold for 3.5 sec long
Double Press| Press and release 2 times within 800ms
Triple Press| Press and release 3 times within 800ms

Pairing mode is locked when 2 devices are already paired.

UI – Function LED

FOSTER-KT001-WH-01-Wireless-
Headphones-2

UI – Charging LED 

FOSTER-KT001-WH-01-Wireless-
Headphones-3

How to pair 2 devices in Normal mode

  1. System enters pairing mode automatically when PDL is empty.
  2. In order to pair the 2nd device, press and hold the Power button for 2 seconds long in power off.

[Important]
In case that headset does not enter pairing mode, the key operation is locked. It is necessary to clear PDL by executing factory reset.

U.S.A
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

  1. This device may not cause harmful interference, and
  2. this device must accept any interference received, including interference that may cause undesired operation

FCC CAUTION

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment Properly shielded and grounded cables and connectors must be used for connection to host computers and / or peripherals in order to meet FCC emission limits.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between the equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Consult the dealer or an experienced radio/TV technician for help.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines as this equipment has very low levels of RF energy.

EU
Safety instructions for rechargeable Lithium-ion battery pack
This product has a built-in rechargeable lithium ion battery pack.

Danger
Do not use or handle the battery under the following conditions.

  • use, storage or transportation of the battery in an excessively high or low temperature environment;
  • disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery;
  • leaving a battery in an extermely high temparature surrounding environment;
  • leaving a battery in an extermely low air pressure surrounding environment;

Handling under the above conditions may cause battery leakage, and in extreme cases, explosion, heat genera tion, fire, smoke or gas generation.
Warning

  • Do not charge a product with built-in rechargeable batteries if ambient temperatures above 0-45 ℃.
  • Product with built-in rechargeable batteries should not be heated to temperatures above 60 ℃.
  • Do not charge the product if there is a clear defect in the product that contains the rechargeable battery.

Disposal Method
Dispose of product with built-in rechargeable batteries at special collection points or return them to your specialist dealer.

Information on Disposal for Users of Waste Electrical & Electronic Equipment
This symbol on the product means that used electrical and electronic equipment should not be mixed with general household waste.
The correct disposal will help prevent potential negative effects on human health and the environment.
For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation.
For more information about collection and recycling of used products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items.

For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union This symbol is only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal.

CU declaration (Russia/Belarus/Kazachstan)

  • Product name(Bluetooth® Headphone) and/or model name (KT001 WH 01)
  • Manufacturer name and / or brand name (FOSTER ELECTRIC CO.,LTD.)
  • Country of origin (China)
  • The inquiry destination of the product
    (Foster Electric Co., Ltd.
    1- 1-109, Tsutsujigaoka, Akishima City, Tokyo,

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by Foster Electric Company Limited is under license. Other trademarks and trade names are those of their respective owners.

Scope of Delivery


  1. Headphones
  2. USB Cable

Label Position (Behind Earpad)FOSTER-KT001-WH-01-Wireless-
Headphones-5

Documents / Resources

| FOSTER KT001 WH 01 Wireless Headphones [pdf] User Manual
619755, 2ASG7619755, KT001 WH 01, Wireless Headphones, KT001, WH 01 Wireless Headphones, KT001 WH 01 Wireless Headphones, Headphones
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals