sudio Earbuds User Manual
- June 7, 2024
- Sudio
Table of Contents
sudio Earbuds User Manual
PRECAUTIONS AND USAGE
Do not use the product in other ways than described. Handle with care at all
times and protect from damage. Do not expose the earphones to heat, magnetism,
cold, damp environments or abnormal wear and tear e.g. by bending or pulling
them. Avoid dropping, strong impact or winding the cable tightly. Clean with a
slightly damp fabric.
The WEEE-symbol means that the product should Not be mixed with normal
household waste, please return to facilities for Waste Electrical and
Electronic Equipment.
WARNING:
Never listen to music at an uncomfortably high volume, this may permanently
damage your hearing. Never use the earphones in traffic or in other places
where your hearing is needed to perceive dangers. Always store small
accessories out of small children’s range. Always lower the volume before you
connect.
SPECIFICATIONS
- Bluetooth Version: V5.0, class II
- Bluetooth Profile: HFPv1.7 HSPv1.2 A2DPv1.3 AVRCPv1.6, SPP1.2
- Bluetooth Range: 15M
- Music Time: 7 hours
- Talking Time: 7 hours
- Charging Time: 1.5H
- Charging Type: 3.7V, 50mAh (earphone) rechargeable lithium polymer battery.
- Operating Temperature: -10 – 55°C
- Charging case: 500mAh (case) rechargeable lithium polymer battery.
POWER ON / PAIRING MODE
Lift both earphones from the charging case and they will be in pairing mode.
Select “Sudio Tolv” in the bluetooth list on your device.
MUSIC CONTROLS
- Play/Pause = Press button once
- Next song = Press R button two times
- Previous song = Press L button two times
PHONE CONTROLS
- Answer call = Press R once
- Reject call = Press and hold R for two seconds
TROUBLESHOOTING
If the earphones are behaving unexpectedly or you’re having difficulty pairing, we recommend a reset.
1. Turn off both earphones by pressing and holding both buttons for six
seconds. Start the earphones again by pressing and holding both sides for
thirteen seconds, until the lights stop blinking.
2. Put the earphones back in the case and wait for 10 seconds. They are now
reset.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
sudio Earbuds User Manual – Download [optimized]
sudio Earbuds User Manual – Download
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>