AT T H100 Bluetooth Wired Headphones User Manual
- June 5, 2024
- AT&T
Table of Contents
User’s Manual
H100
Bluetooth® Wired Headphones
Welcome Thank you for buying AT&T H100
Bluetooth® Wired Headphones
Features
- Bluetooth 5.0 technology with amazing sound
- Built-in microphone with echo cancellation
- Full controls for playback and calls
- 3.5 mm auxiliary input jack
What’s Included
Unpack the Bluetooth® headphones and make sure all accessories are put aside so they will not be lost.
Safety Information
Important Safety Instructions
Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in this user’s manual and on the H50.
- Attachments – Do not use attachments not recommended by the manufacturer.
- Water and Moisture – The unit should not be used near water. For example: near a bathtub, washbowl, kitchen sink, laundry tub, swimming pool or in a wet basement.
- Objects and Liquid Entry – Care should be taken so that external objects do not fall into and liquids are not spilled onto any openings or vents located on the product.
- Power Source – The unit should be connected only to a power supply of the type described in the operating instructions or as marked on the unit. If you are not sure, please consult the dealer or local power company.
- Heat – The unit should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.
- Servicing – The user should not attempt to service the unit beyond those methods described in the user’s manual. Opening or removing covers will expose you to dangerous voltage and other hazards. Service methods not covered in the user’s manual should be referred to qualified service personnel.
Getting Started
Location of Main Unit Controls
Operational Instructions
Charging
Charge your H100 through any USB jack or wall charger. The LED indicator will
glow red when charging. Before using it for the first time, charge at least 4
hours. After the the first charge, the headset will charge in 2 to 3 hours,
and the LED indicator will turn off when the charge is complete.
Note: When the battery is fully charged, the LED indicator will change to
blue.
Power ON/OFF
Press and hold the ON/OFF button for 2-3 seconds to switch the headset on. The
LED will flash blue when powered on. Press and hold the ON/OFF button for 3
seconds to switch the headset off. When powering off, the LED will flash blue
and then turn off indicating the headset is off.
Pairing
While the headset is off, press and hold the ON/OFF – for 2-3 seconds to start
pairing mode. Once the headset is in the pairing mode (the LED will flash red
and blue), select
‘H100’ among discovered Bluetooth devices on the phone to Pair.
Note: If the headset is not paired with a Bluetooth device in 3 minutes,
it will turn itself off.
Making Phone Calls
Making a call
Once paired, use your mobile device to dial a number as usual. Once connected,
the call will be heard on your H100 headset.
Answer a call
When receiving a call, press the Play/Pause button to answer the call.
Ending a call
While talking on the phone, press the Play/Pause button to end the call.
Listening to Music
Play/Pause
Press the Play button to launch the phone’s music player and to start
listening to music. While listening to music, press the Pause button to pause
or to resume play.
Song selection
While music is playing, press the |+| or |-| buttons to skip or go to previous
songs.
Answer a call while listening to music
When receiving a call, press the Play/Pause button to answer the call. Press
the Play/Pause button while on the phone to end the call. When receiving a
call, press and hold the Play/Pause button to reject the call. (Music will
resume playing when the call is rejected.)
Volume control
Press and hold the Volume |+| and Volume |-| buttons to adjust the volume
level.
LED Indicator Chart
| Status | Indicator |
|---|---|
| Powering ON | Blue and red lights flashing rapidly |
| Powering OFF | LED turns off |
| Low battery | Blinking red & the headset emits a beep |
| Charging | Solid red light |
| Pairing mode | Blue and red lights flashing rapidly |
| Connection complete | Blue light blinks every 3 seconds |
| Playing music | Blinking blue light |
Troubleshooting
| Symptom | Solution |
|---|---|
| Music is not streaming over Bluetooth | Check to make sure both devices are |
paired and connected over Bluetooth.
Restart the HSO to auto-connect with your Bluetooth device.
No power| Make sure the HSO is fully charged.
HSO does not answer phone calls| Check to make sure both devices are paired
and connected over Bluetooth. Restart the HSO to auto-connect with your
Bluetooth device.
Music does not resume after ending a call| Press play to resume music.
Compliance with FCC Regulations
Caution!
The user is cautioned that changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to
operate the equipment.
The equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
Radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from which the receiver is connected.
- Consult the dealer or an experienced radio/television technician for assistance.
This equipment complies with FCC’s RF radiation exposure limits set forth for
an uncontrolled environment. The antenna(s) used for this transmitter must be
installed and operated to provide a separation distance of at least 20 cm from
all persons and must not be collocated or operating in conjunction with any
other antenna or transmitter. Installers must ensure that 20 cm separation
distance will be maintained between the device (excluding its handset) and
users.
THE SPECIFICATION AND EXTERNAL APPEARANCE OF THE HEADPHONES ARE SUBJECT TO
CHANGE WITHOUT PRIOR NOTICE.
If at any time in the future you should need to dispose of this product, please note that waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.
Warranty Information
Limited Warranty
The AT&T brands are used under license. Any repair, replacement, or warranty
service, and all questions about this product should be directed to Concept
101 LLC at www.att.com/electronics or call 1
888-920-8680 from the USA or Canada.
Concept 101 LLC warrants to the original purchaser that the product will be
free from defects in material, parts, and workmanship for the period
designated for this product. The warranty commences the day the product is
purchased and covers up to a period of one (1) year. Concept 101 LLC agrees
that it will, at its option, replace the defective product with either a new
or remanufactured headset equivalent to your original purchase during the
warranty period. Should the Parts warranty period exceed the Labor warranty
period, Concept 101 LLC will supply at no charge for the remainder of the
Parts warranty, any new or remanufactured replacement parts as required by the
product. During this period all labor and service charges will become the
responsibility of the customer.
Exclusions: This warranty does not apply to the appearance or exterior of the product which may have been damaged or defaced, altered, or modified in design or construction. This warranty does not apply if the serial number is altered or removed, or if there is any damage due to a power line surge, user damage to the AC power cord, connection to an improper voltage source, general misuse, accidents, or repair attempts by unauthorized service agents. Other exclusions include ear pads, rechargeable, and non-rechargeable batteries.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE CUSTOMER; Concept 101 LLC SHALL NOT BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT, EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OF FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED TO THE DURATION OF THE WARRANTY.
Some states do not allow the exclusion or limitations of incidental or consequential damages, or limitations on how long the warranty lasts. In these cases the above exclusions or limitations may not apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Warranty Information
Obtaining Service : To obtain service, product literature, supplies or
accessories please call 1 888-920-8680,
or visit our website,
www.att.com/electronics, to create a ticket
for exchange/repair. Please make sure to provide the date of purchase, model
number, and a brief description of the problem. Our customer service
representative will contact you or send detailed return instructions.
Concept 101 LLC does not warrant that the headset will work properly in all environmental conditions, and makes no warranty and representation, either implied or expressed, with respect to the quality, performance, merchantability, or fitness for a particular purpose other than the purpose identified within this user’s manual. Concept 101 LLC has made every effort to ensure that this user’s manual is accurate and disclaims liability for any inaccuracies or omissions that may have occurred. Information in this user’s manual is subject to change without notice and does not represent a commitment on the part of Concept 101 LLC. Concept 101 LLC reserves the right to make improvements to this user’s manual and/or to the products described in this user’s manual at any time without notice. If you find information in this manual that is incorrect, misleading, or incomplete, please contact us through our website.
Specifications
– Bluetooth – 5.0
– Charging time – approximately 2 hours
– Battery – 3.7V 200Mah
– Playback Time – up to 4 hours
Memo
Purchase date:
Place of purchase:
www.att.com/electronics
© 2020 Concept 101 LLC. All Rights Reserved. AT&T and the AT&T logo are
trademarks of AT&T
Intellectual Property licensed to Concept 101 LLC, New York, New York 10018.
Printed in China.
Issue 1.1 AT&T 7/2020.
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. Other
trademarks and trade names are those of their respective owners.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>