HoMEDiCS AP-T10 TotalClean 4-In-1 Air Purifier Instruction Manual

: June 5, 2024
: Homedics

Table of Contents

PRODUCT FEATURES
OPERATING INSTRUCTIONS
FILTER REPLACEMENT
CLEANING & MAINTENANCE
TROUBLESHOOTING
Documents / Resources

Register your product today at
www.homedics.co.uk/product-registration

TOTALCLEAR® 41Ni AIRPURIFIER
instruction manual
AP-T10-EU

2 YEARGUARANTEE

PRODUCT FEATURES

CONTROL PANEL

ALL-IN-ONE HEPA-TYPE FILTRATION SYSTEM
HEPA-TYPE FILTRATION
Removes up to 99% of airborne particles as small as 0.3 microns, such as allergens, pollen, dust, germs, pet dander, odour, mould spores, and smoke from air that passes through the filter.
CARBON ODOUR FILTRATION
Reduces household odors and VOCs (volatile organic compounds)/gases as shown by independent laboratory testing.
PRE-FILTER
Captures large particles.
IONISER WITH ON/OFF
When on, the ioniser assists in the air purification process.
2 SPEEDS
Low and high.
REPLACE FILTER INDICATOR
Illuminates when it is time to replace the filter.
SUGGESTED ROOM SIZE 40M² /H / 427FT² /H. Portable air purifiers will be more effective in rooms where all the doors and windows are closed.
AIR CHANGES PER HOUR
This air purifier will purify the air in a 40M² / 427 FT2 room (assuming a 2.43 M/8 FT ceiling) once per hour on high speed in a closed room. The airflow rate is 97M³/H / 3418 FT³ /H.
OIL TRAY
Includes 3 essential oil pads. Use with essential oil (not included) to deliver scent into the air.

OPERATING INSTRUCTIONS

BEFORE TURNING THE UNIT ON

Take the air purifier out of the box and remove the clear protective plastic bag.
Place the air purifier on a firm, level surface.
Plug the power cord into a standard AC outlet.

POWER BUTTON AND FAN SPEED SETTINGS

To turn the air purifier on, press the power button.
This air purifier has 2 fan speed settings: low and high. The higher the fan speed setting, the faster the air will be purified. To select or change fan speed, press the fan speed
button until the desired setting is reached.

IONISER SETTING WITH ON/OFF
Ion particles have a positive or negative charge that attaches to airborne particles, making them easier to be captured by the filtration system. Press the ionizer ION button to turn the ionizer on. The blue light will glow to indicate the ioniser is in use. Press the ionizer ION button again to turn the ionizer off.
NOTE: Dust particles may accumulate on surfaces around the air purifier when the ioniser is in use. These dust particles can be vacuumed or wiped away with a soft, damp cloth.
NOTE: You may hear occasional popping sounds when the ionizer is used. This is normal.
NOTE: The ionizer produces less ozone than the UL-established limits of 0.05 ppm. Ozone may be harmful around birds and small pets. To prevent ozone buildup, use the ionizer feature in a well-ventilated area.
NIGHTLIGHT
The nightlight has 3 options. Press the nightlight button once to turn the blue nightlight on. Press again to turn the blue nightlight ring and the display lights off. Press a third time to turn the display lights on.
OIL TRAY
Use essential oil (not included) to deliver scent into the air.
NOTE: For use with the included HoMedics essential oil pads only. Do not add essential oils anywhere else in the unit as it may cause damage.
NOTE: Do not leave a filled essential oil pad in the air purifier if it will be out of use for a long period of time.
ARE ESSENTIAL OILS SAFE TO USE AROUND PETS?
We should always exercise caution when using essential oils around our pets. Keep all essential oil and aromatherapy products (like diffusers) out of reach of pets. Keep open bottles away from pets to avoid internal consumption. We do not recommend the topical use of essential oils on pets, as they have a strong sense of smell and cannot get rid of the oil if they don’t like it or it is disturbing them. When diffusing essential oils around pets, always diffuse in a well-ventilated area and leave an option for them to remove themselves from the space, such as leaving a door open. Every animal is different, so carefully observe how each animal responds when introducing an essential oil for the first
time. If irritation occurs, discontinue the use of the essential oil. We recommend seeking medical attention if ingestion of essential oil occurs.
ADDING ESSENTIAL OILS
Please note that allergy friendliness is no longer guaranteed if the Essential Oil Scent Tray function is used, since essential oils may lead to allergic reactions.
WARNING: Putting oil anywhere but the oil tray will damage the air purifier.

| 1. The oil tray is located on the side of the air purifier.
---|---
| 2. Push to open and remove the tray.
| 3. Place 1 aroma pad (3 included) into the oil tray.
| 4. Add 5–7 drops of essential oil to the pad. You may use it more or less depending on personal preference.
WARNING: Only place essential oil on the pad and NOT directly into the tray.
| 5. Place the oil tray back in its compartment and push to close. The scent will start automatically
when the air purifier is turned on.

FILTER REPLACEMENT

REPLACE FILTER LIGHT
The replace filter light illuminates when it is time to replace the HEPA-type filter based on the air purifier’s hours of use.
REPLACING THE HEPA-TYPE FILTER
For optimal performance, replace every 12 months under normal usage conditions.

| 1. Unplug the air purifier and turn it upside down. Turn the filter cover as indicated to remove.
---|---
| 2. Remove the filter cover and set it aside.
| 3. Pull to remove the old filter
| 4. Slide the new HEPA-type filter into the filter cavity.
| 5. Reinstall the filter cover and turn to the right to lock it in place.
| 6. Plug the power cord into a standard AC outlet. Turn the air purifier on. Press and hold the power button for 3 seconds to reset the indicator.

CLEANING & MAINTENANCE

CLEANING THE PRE-FILTER
NOTE: For best performance, vacuum the pre-filter once a month under normal usage.

Unplug the air purifier.
Remove the HEPA-type filter as described in the Replacing the HEPA-type Filter section.
Vacuum the outside of the HEPA-type filter using the brush attachment of your vacuum cleaner, cleaning it thoroughly.
Place the HEPA-type filter back into the air purifier and close the grille.
Plug the power cord into a standard AC outlet.

TO CLEAN THE OIL TRAY
Open the oil tray and remove the pad. Essential oil pads should be changed when switching to a different essential oil scent. If continuing to use the same scent, set the essential oil pad aside for reuse. Wipe down the inside of the foil tray with a soft cloth. Place the essential oil pad back in the tray and close.
NOTE: Leave the essential oil pad out of the oil tray when storing.
WARNING: The appliance is only to be used with the recommended vaporizing medium. The use of other substances may give rise to a toxic or fire risk.

FOR BEST PERFORMANCE

NEVER use water or any household cleaners or detergents to clean the HEPA-type filter.
Clean off the outside of the unit with a dry cloth as needed.
NEVER use water, wax, polish, or any chemical solution to clean the outside of the unit.
Clean off the grille cover using a damp cloth or the brush attachment of your vacuum as needed.
Vacuum the pre-filter monthly under normal usage conditions.
Replace the HEPA-type filter every 12 months under normal usage conditions.
Always use a genuine HoMedics replacement filter for optimal performance.

To purchase genuine HoMedics replacement/spare parts please visitwww.homedics.co.uk
3 Pack of aroma pads – ARM-PAD3
Aroma tray – AP-T10WTARM
HEPA filter – AP-T10FLR
Essential Oils:
ARM-EO15LAV
ARM-EO15EUC
ARM-EO15ORG
ARM-EOGPF
ARM-EO15LEM
ARM-EOLMG
ARM-EO15WD
ARM-EO15OU
ARM-EO15GG
ARM-EO15BC
ARM-EO15PIN
ARM-EO15WNL
ARM-EO15RSM

TROUBLESHOOTING

PROBLEM| POSSIBLE CAUSE|

SOLUTION

---|---|---
Unit will not operate|

Unit is not plugged in
Power button was not pressed
No power to the unit
HEPA-type filter is not installed correctly
Grille cover is not installed correctly

|

Plug unit in
Press the power button to turn the power on
Check fuses, try a different outlet
Reinstall the HEPA-type filter
Reinstall the grille cover

Reduced airflow|

The back grille may be blocked
Pre-filter needs vacuuming
The HEPA-type filter needs to be replaced

|

Check to make sure nothing is blocking the back grille and air outlet
Vacuum the pre-filter with the brush attachment of your vacuum cleaner
Replace the HEPA-type filter

Reduced odor removal|

The HEPA-type filter needs to be replaced

|

Replace the HEPA-type filter

Excessive noise|

The unit is not level

|

Place the unit on a flat, level surface

Replace filter light remains lit after filter replacement|

The replaced filter indicator needs to be reset

|

Press and hold the ionizer button for 3 seconds until the replace filter light turns off

Display lights are off|

Nightlight setting

|

Press the nightlight button until the desired lights are on/off

Manufacturer & UK Importer: FKA Brands Ltd, Somerhill Business Park, Tonbridge, Kent TN11 OGP, UK EU Importer: FKA Brands Ltd, 29 Earlsfort Terrace, Dublin 2, Ireland Distributor in Australia: HoMedics Australia Pty Ltd, 14 Kingsley Close, Rowville, VIC 3178, Australia Customer Support: +44(0) 1732 3785571 [email protected]

IB-APT10EU-1220-01

Documents / Resources

| HoMEDiCS AP-T10 TotalClean 4-In-1 Air Purifier [pdf] Instruction Manual
AP-T10, TotalClean 4-In-1 Air Purifier, AP-T10 TotalClean 4-In-1 Air Purifier
---|---