FALCON RIDGE Polaris RZR RS1 Tinted Hard Top Instruction Manual

FALCON RIDGE Polaris RZR RS1 Tinted Hard Top

Instructions for Installation and Care of Polaris RZR RS1 Tinted Polycarbonate Roof

1. Be sure to read these instructions thoroughly before opening and installing the Polaris RZR RS1 Tinted Polycarbonate Roof.
2. Check over the parts included in the cartons with the parts list shown below:
   • 1 5/8″ Loom Clamps 6 each
   • 1 1/4” Black Bolts 6 each
   • Large Black Washers 6 each
   • Large Rubber Washers 6 each
   • Small Black Washers 6 each
   • Black Locknuts 6 each
   • 21” Small Side Bulb Gasket 1 each
   • 32” Small Side Bulb Gasket 1 each
   • Polycarbonate Roof 1 each
3. Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the protective film. Next take the 32” piece of rubber gasket and starting at one end firmly place across the back end of the Roof. You may need to trim any excess. See Photo Below.
4. If you are using your roof with a windshield the 21″ rubber gasket is provided to create a seal between the two parts. If not put in a safe place to use if and when you get a windshield. If needed install across the front of the roof as shown in the photo below.
5. Now use the remaining hardware and install the roof to the RS1. Start with the two rear holes and work your way to the front. Make sure that the rubber gasket in the rear is properly sealed against the plastic. Diagram below shows how to use the hardware.

Return Policy

If for any reason you choose to return this product it must be returned within 30 days from date item is received. You MUST package the product exactly as it was originally packaged from the factory to get a full refund for the product! The vinyl windows should never be folded when packaging in the box or for storage purposes. Lay all the windows on top of each other with the canvas folded in between and the paper (if available) on both sides of the windows. All returned products will be inspected upon arrival at the production facility and must be in unused, factory-new condition to receive a refund – a 25% restocking fee will apply. If ordered from Falcon Ridge please call at 606-845-7439 to gain a return authorization number, use our preferred shipping carrier (UPS) to return the item (unless the item is defective, you are responsible for paying the shipping to return the item.) Any returns submitted to Falcon Ridge without a return authorization number will be charged a 20% restocking fee. If ordered from one of Falcon Ridge’s many distributors, you must first call them and see what their return policy is. Once your item reaches our production facility, our customer satisfaction team will inspect your item to ensure unused, factory-new condition. NOTE: All windshields must be returned with the original protective film intact and not removed. Do NOT REMOVE if you have any intentions of returning the item. Refund/ replacement of a windshield will only be processed on items with original protective film or if the windshield is defective. Items must be properly packaged in the original shipping carton to protect them during transit and ensure your returned item arrives back factory fresh, and in new resalable condition (any  returned items that have been used, altered or damaged in any way will not be subject for a refund.) All contents including instruction manuals, accessories, hardware, Velcro, etc. must be  included in your return shipment. Only items in OEM factory new condition will be approved.Once returned items are received, credit will be issued to the original credit card/ payment method used for the purchase. Outbound shipping and return shipping cost will not be refunded. Please allow 4 to 6 weeks for your refund to be processed.

To The Owner of this Product:
Thank you for purchasing one of Falcon Ridge’s Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product. Please refer to the return policy in this case for more information. 1 Year Warranty includes any defect in material or workmanship within this time frame we will gladly correct the problem or replace the enclosure, tops &/or windshield. Upon submitting for the correction or replacement we will need to receive pictures of the defect in material or workmanship along with the receipt from the date of purchase.
Thank you,
Falcon Ridge

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>