dns WD-234A Wireless Car Charger Instruction Manual

: June 6, 2024
: dns

Table of Contents

PARTS INCLUDED
COMPONENT IDENTIFICATION
INSTALLATION
SPECIFICATIONS
RF Exposure Warning Statements:
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

WIRELESS CAR CHARGER
Instruction Manual

WD-234A

PARTS INCLUDED

Device holder
Wireless charger
Vent mount
Suction mount

COMPONENT IDENTIFICATION

Clip
Charging coil
Charger
Bottom clip
Tightening knob
Ball joint
Air vent clip
Charging LED
Micro USB port

INSTALLATION

Place the screw cap (threads facing up) over the mount’s ball joints.

Align the device holder over the mount’s ball joint.

Snap the device holder onto the mount’s joint, you will hear a “snap” when it is properly connected.

Place the holder onto the air vent or windshield as desired.

Adjust as necessary.

Adjust the bottom clip to ensure the wireless charging pad is in the correct place on your device.

The air vent clip and suction mount can be adjusted to the optimum angle for your vehicle.

UNDERSTANDING THE LED LIGHTS
Green LED ON–Charging
Green LED OFF–Standby
Blinking LED–Foreign object in the charger
Blinking LED–Overheat warning
Blinking LED–Voltage too high

WARNING
DO NOT put metal objects on the charger Keep the charger dry
DO NOT use if damaged
DO NOT charge with a damaged, broken, or exploded battery
DO NOT use or under 0ºC or over 30ºC
DO NOT store in frigid temperatures to avoid moisture build-up inside the charger
DO NOT open or repair
DO NOT throw, beat or shake to avoid internal damage

SPECIFICATIONS

Charging modes: 5W/7.5W/10W
Input: 5V/2A; 9V/1.67A
Charging distance: <0.2″ (5mm)
Efficiency: 75%
Size: 4.33×3.8×2.13in
FCC ID: ZBCWD234A

Qualcomm Quick Charge is a product of Qualcomm Technologies, Inc., and/or its subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United States and other countries. Quick Charge is a trademark of Qualcomm Incorporated.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

RF Exposure Warning Statements:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body.

Please Recycle