Dongguan Xing Yue Electronic XO-10013 Speaker User Guide
- June 6, 2024
- Dongguan Xing Yue Electronic
Table of Contents
Dongguan Xing Yue Electronic XO-10013 Speaker
How to use speaker (charging box)
Bluetooth Setup:
Press and hold power button to turn ON the speaker ,LED Indicator will flash BLUE when in pairing mode. Turn on the Bluetooth function on mobile device, select “Cling Bluetooth Speaker”pairing name.LED will turn solid BLUE if successfully paired, Speaker will automatically pair if the mobile device has been paired before.If disconnect Bluetooth after 5 mins, the speaker Bluetooth will auto shut off. Long press Power button to turn off the speaker.
Playing Music
It has a built in microphone, can answer phone calls on speaker. Short press to control volume, long press to control audio tracks. It will auto off after disconnect Bluetooth 5mins. With tones prompts. Playback time at max volume is about 3hrs.
Charging the speaker
Connect the provided charging cable to a power source and to the USB port on the bottom of the speaker. Red LED light when charging the speaker, light turn OFF when fully charged.
How to use the earbuds
Bluetooth pairing
Remove earbuds from case, prompt a voice “Power on”, then a beep to indicate both earbuds sync to each other, now main earbud LED flash Red& Blue, secondary earbud flash Blue slowly. Turn on the Bluetooth function on mobile device, Select “TWS Earbuds” pairing name.After connect Bluetooth, prompt a voice “connected”.now both earbuds LEDs flash blue slowly.Disconnect Bluetooth will prompt a voice “Disconnected”. Long press earbuds button about 5 seconds to power off earbuds and hear a voice prompt “Power off”. If disconnect Bluetooth after 5 mins, the earbuds will auto shut off.
Playing Music
- Play/Pause/Answer call/Hang up – One tap/touch/click on butto
- Next track – Double tap/touch/click on button, Right Earbuds
- Previous track – Double tap/touch/click on button, Left Earbud
- Activate voice assistant – Long press on button 2 seconds, both earbuds
- Reject call – Long press on button 2 seconds when calling.
- long press the button 5 seconds to turn off , long press 3 seconds to turn on.
Charging the earbuds
When case has power, put one earbud into case this earbud will auto start
charging until earbuds fully charged, the other earbud will remains on. Put
both earbuds into case, earbuds will turn off and start auto charging until
earbuds fully charged. Earbuds playback time at max volume: about 4hours.
Speaker charge the earbuds: Solid Red LED on earbuds when charging and solid
Blue on case, LEDs on both earbuds and on case all turn off when earbuds are
fully charged.
Warning: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Radiation Exposure Statement
- The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.