MIRFAK Audio WE10 Dual Wireless Microphone System User Manual
- June 5, 2024
- MIRFAK Audio
Table of Contents
MIRFAK Audio WE10 Dual Wireless Microphone System
Transmitter Overview
- Recording (Switch)
- MicroSD Card Slot
- Power Button
- CHARGE
- 3.5mm Audio Output
- REC
- LINE
- Type-C
- Built-in Microphone
Transmitter Operating Instructions
- Press the power button for 3s to turn on or turn oF the transmitter, triple-press to enter code matching mode.
- Turn the recording button to REC(close to the storage interface) to start recording, turn the record button to STOP(away from the storage interface) to stop recording.
- The storage interface has a MicroSD card slot, which can support up to 64G.
- The audio interface is a standard 3.5mm 4-pole audio interface for external microphones. If there are no external microphones, please use the built-in microphone.
- The REC(blue) indicates the recording status and is used to show whether the recording is in progress.
- The LINE (blue) indicates the status of code matching, which is used to indicate whether the connection between the transmitter and the receiver is intact.
- The CHARGE (blue) indicates the charging status. The blue light is always on when charging, and is oF when fully charged.
- This machine adopts Type-C charging interface, supports standard Type-C charging, and the charging voltage is 5V,0.4A.
- The microphone uses an omnidirectional condenser microphone, and the working distance is within 30cm.
- The battery uses a built-in 500mah polymer battery, the charging time is about 100 minutes, and it can be used for more than 3.5 hours.
Receiver Overview
- 3.5mm Microphone
- Type-C
- Gain
- Headphone
- Low-Cut
- Power Button
- Mute
Receiver Operating Instructions
- Press the power button for 3s to turn on or turn of the receiver, triple-press to enter code matching mode.
- The gain button is to adjust the gain, which can be cyclically switched between -18db, -6db, 0, +3db, and +6db.
- The low-cut button is to adjust the frequency, which can be cyclically switched between 0Hz, 170Hz, and 230Hz.
- The mute button is to mute the receiver, and the mute function is of by default. Press lightly to turn on the mute function.
- The Type-C interface is the charging interface, which supports standard Type-C charging, and the charging voltage is 5V, 0.3A.
- The 3.5mm Microphone① is an audio output interface, through the configured audio cable, the transmitted voice signal can be output to devices like mobile phones, DSLR, and other devices.
- The Headphone② is an monitoring interface, using headphones, you can monitor the voice signal of the Transmitter in real time.
- The Receiver uses a built-in 350mah polymer battery, the charging time is about 80 minutes, and it can be used for more than 4hours.
Read User Manual Online (PDF format)
Loading......