atomi smart AT1156 Smart Bridge User Manual
- June 5, 2024
- Atomi Smart
Table of Contents
AT1156
Smart Bridge
User Manual
AT1156 Smart Bridge
Product name: Smart Bridge
Product Model: AT1556
Category: Gateway
Communication mode: Wi-Fi, Bluetooth Mesh(SIG)
Rated input: 5V-1A
Operating temperature: -0°Cf”50° C
Working humidity: 0%-95%RH, no condensation
Supported operating system: Android 5.0 or i0S12.0 or above
Connection mode:
-
- Step 1: Plug in the smart bridge APP “+”
2. Step 2: Open the Tuya APP and press “+” in the upper right corner to add the smart bridge.
- Step 1: Plug in the smart bridge APP “+”
-
APP
-
Step 3: Through the smart bridge, add the other smart devices as prompted by the APP.
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not
expressly approved by the party responsible for compliance. such modifications
could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirements.
To maintain compliance with FCC’s RF exposure guidelines, the distance must be
at least 20 cm between the radiator and your body and fully supported by the
operating and installation.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>