GE CLEDA199CDEN LED Lamp Instructions
- June 5, 2024
- GE
Table of Contents
GE CLEDA199CDEN LED Lamp
INTRODUCTION
CYNC Entertainment Full Color A19 CLEDA199CDEN, input 120Vac, frequency was 60Hz, high efficiency, safety & stability output. Use Bluetooth 4.2 and Wi-Fi 2.4G Hz chip technology to realize the far distance control. Through the APP to control the PWM signal to dim and even control the switch on & off of the bulb. Product features:
- Controlled by Bluetooth 4.2 and 2.4G Wi-Fi to realize the far distance control.
- CCT is 2200K to 7000K.
- With advanced chips to make sure the bulb with high efficiency, low consumption and stability.
- Internal constant current output to make sure the high power conversion efficiency and stability output.
| Product Name | LED LAMP |
|---|---|
| Brand Name | GE |
| Model No. |
CLEDA199CDEN
Working Voltage| 120Vac
Bluetooth Specification| Version 4.2
Wi-Fi Specification| 2.4G Hz
Frequency Range
| WIFI:2412- 2462MHz
BLE:2402~2480MHz
Channel Number
Bluetooth
|
40
Channel Separation
Bluetooth
|
2MHz
Type of Modulation
Bluetooth
|
GFSK
Data Rate Bluetooth| 1Mbps(GFSK)
Channel Number Wi-Fi| 11
---|---
Channel Separation Wi-Fi| 5MHz
Data Rate Wi-Fi
| 802.11b:11, 5.5,2,1 Mbps
802.11g: 54,48,36,24,18,12,9,6 Mbps
802.11n: MCS0~7
Antenna Type| Chip Monopole Antenna
Peak Antenna Gain
Bluetooth
|
-1.52dBi
Peak Antenna Gain Wi-Fi|
-1.52dBi
For additional help, regulatory and safety Information, please go to:
Federal Communications Commission (FCC) Interference Statement. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifications not expressly
approved by the party responsible for compliance. Such modifications could
void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
-
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body.
CAUTION: -
DO NOT USE WITH STANDARD DIMMERS, SEE INSTRUCTIONS
-
NOT FOR USE IN TOTALLY ENCLOSED LUMINAIRES
-
SUITABLE FOR DAMP LOCATIONS
-
THIS DEVICE IS NOT INTENDED FOR USE WITH EMERGENCY EXITS
Only use the control provided with or specified by these instructions to control this lamp. This lamp will not operate properly when connected to a standard (incandescent) dimmer or dimming control. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator & your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>