ZYXEL PM7510-R0 XGS PON Bridge ONT with 10G LAN User Guide
- June 5, 2024
- ZYXEL
Table of Contents
PM7510-R0 XGS PON Bridge ONT with 10G LAN
User Guide
Package Contents
See the User’s Guide at www.zyxel.com for more information, including customer support and safety warnings.
Hardware Connections
| 
|
---|---|---
Warning! Do NOT remove the PM7510-R0 from the fiber box or open the fiber box.
Opening the fiber box could damage the fiber optic cable.
ONLY qualified service personnel should service or disassemble the PM7510-R0
and fiber box. Contact your ISP for further information.
- Find the PM7510-R0 installed by the ISP on the fiber box.
- Connect a computer, router, or gateway to the 10G LAN port using the white Ethernet cable.
- Use the included power adapter to connect the power socket to a power outlet.
- Press the cable clip to open it. Close it around the power adapter cable to prevent accidental unplugging.
POWER| Green On – The device is turned on and has finished booting.
Blinking – Starting up.
Read On – System failure.
Blinking – Firmware upgrading. Off
Not receiving power.
---|---
UPS| Green On – The AC power is off and the UPS (battery backup) is providing
power normally.
Blinking – The battery is working abnormally, such as the voltage going
outside the expected range.
Off The battery is not in use or cannot recharge.
ON| Green On – PON link to the OL Tis up. Receiving an optical signal of
normal strength.
Blinking – Trying to establish a link to the OL T.
Red On – PON link to the OL Tis down.
Blinking – The received optical signal is too weak.
10G LAN| Located on the Ethernet connector.
Green On – Ethernet device connected.
Green Blinking – Traffic.
Off No Ethernet device connected.
US Importer
Zyxel Communications, Inc
1130 North Miller Street Anaheim, CA 92806-2001
https://www.zyxel.com/us/en/
Copyright© 2022 Zyxel Communications Corp. All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>