crest CRFPL Smart Fingerprint Padlock User Manual

: June 5, 2024
: CREST

Table of Contents

Know your Lock
Product Specifications
Adding your Fingerprints
Restore Factory Settings
Charging Prompt
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

crest CRFPL Smart Fingerprint Padlock User Manual

Know your Lock

Lock Shackle
LED Indicators
Fingerprint Reader
Lock Body
Micro-USB Charging Port

Product Specifications

Unlock Features: Fingerprint
Fingerprint Storage: 10 Fingerprints
Charging Type: Micro-USB
Emergency Unlock: yes
Battery Type: 150mAh Lithium Battery
Voltage Input: 5V DC
Product Size: 76 x 46 x 13mm
IP Rating: IPX2
Working Temperature: -10°C – 50°C

Before using for the first time, ensure the lock is fully charged

Adding your Fingerprints

Register Two Fingerprints for the First Time:
(2 Fingerprint sets are to be set up on the initial scanning set up)

Unlock the lock with the fingerprint you want registered and hold the finger in place until the LED turns solid blue.
With the same finger press and release the fingerprint scanner until the LED turns green. This could take up to 15 attempts to capture a strong fingerprint scan.

Register more Fingerprints:

Unlock the lock and keep your finger on the scanner until the LED turns blue. With a different finger press and release the fingerprint scanner until the LED turns green. This could take up to 15 attempts to capture a strong fingerprint scan.

Back-Up Unlocking Code:

After setting the fingerprint, unlock the lock and don’t release your finger until the LED turns white. Release your finger and the LEDwill turn green.
With the LED green, begin setting the code. Tap the scanner the amount of times you wish to have the code set for the green LED. Once completed the LED will turn blue. Now tap the scanner the amount of times you wish to have the code set for the blue LED. Once completed the LED will turn off.

This will be the reset code to reset back to the display/factory settings This can also act as an emergency unlock for people without a fingerprint that has been previously stored.

Note: Ensure this code is remembered for this feature to be used.

Restore Factory Settings

Unlock the lock and don’t release your finger until the LED turns red. Once the LED is red the lock is reset to the factory/display settings.

Charging Prompt

When the fingerprint is unlocked the red LED flashes continuously indicating that the voltage is low and requires charging.
When charging, the LED will stay red. Once fully charged the LED will turn off.

Warning on Water Resistance:

Ensure the lock is not submerged in liquid. A Product with an IPX2 Rating is protected against vertically dripping water when tilted at a 15-degree angle from vertical.

Proudly brought to you by:

PO Box 5658 Brendale
QLD Australia 4500

Customer Support
1800 812 261
wwvv.crest.com.au
AUSTRALIAN OWNED