teesa TSA3535 Personal Blender Owner’s Manual
- June 5, 2024
- teesa
Table of Contents
Personal Blender
Owner’s Manual
Thank you for purchasing the TEESA appliance. Please read this operation instruction carefully before use, and keep it for future reference. The producer does not take responsibility or damage caused by inappropriate handling and use of the product.
SAFETY INSTRUCTIONS
In order to reduce the injuries or damages, follow basic safety precautions applied when using any electrical device, including the following:
-
Read this instruction manual carefully, even if you are familiar with the appliance Keep the manual for future reference.
-
Before connecting the device to the power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
-
Place the device on a flat, stable surface.
-
Clean this device in accordance with instructions listed in the “Cleaning and Maintenance section.
-
ALWAYS turn off the device and disconnect it from the mains supply:
• if it’s not operating correctly
• if there’s an uncommon voice when using
• before disassembling the device
• before cleaning
• when not in use -
When you disconnect the power cord of the device, grasp and pull the plug, not the cord/cable.
-
Keep the device out of the reach of children. Do not leave children unsupervised with the product.
-
This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed. Children should not play with this device children should not perform cleaning and servicing of the device unsupervised.
-
Fixed power cable may only be replaced in an authorized service point.
-
Keep the device and its cord/cable away from heat, water, moisture, sharp edges, and any other factor which may damage the appliance or its cord.
-
Protect the product from strong impact and mechanical stress.
-
Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
-
Do not use the product for purposes different from those displayed in this operating manual
-
Do not leave the appliance unattended when it’s working.
-
The producer of this product is not responsible for damages caused by inappropriate handling and use of the device.
-
ALWAYS disconnect the product from the mains supply when it is not in use.
-
DO NOT use this device if the cord or the plug is damaged, or the appliance is broken.
-
Do not attempt to repair this appliance yourself. Only authorized and qualified personnel may repair this device. Never disassemble this device.
-
Do not use unauthorized accessories.
-
Appliance for indoor and household use only.
-
This appliance is suitable exclusively for food preparation. Do not place anything but food in the appliance.
-
Always securely clamp in place all parts before the motor is turned on. Do not disassemble while the device is operating.
-
Do not touch moving parts. Make sure the motor stops completely before disassembling.
-
Use only original attachments/accessories.
-
Do not operate with empty-load or over-load.
-
Handle the blade with care –it is very sharp.
-
Do not add hot water to the jar
PRODUCT DESCRIPTION
- Upper cover
- Jar
- Blade holder
- Motor base
- Power button
OPERATION
Wash the parts that will have contact with food before first use. Rinse thoroughly with warm water and allow to air dry. Never submerge the device motor base in water or any other liquid.
-
Put the motor base on a flat and dry surface.
-
Cut the food into the cube blocks (max. 15 mm). Put these cube blocks into the jar and add liquid if necessary.
-
Screw the blade holder into the jar. Make sure the blade holder is properly screwed on the jar. Note that the water amount should not exceed the indicated maximum capacity of the jar.
-
Plug into power supply socket. Make sure the voltage indicated on this device matches the power supply voltage.
-
Place the blending jar on the motor body (with blade holder downside) and then turn the blending jar clockwise into the motor base. Press the power switch, the blender starts working. If the blending jar and the motor unit are not locked, the blender won’t operate.
-
Do not run the juicer continuously for longer than 1 minute. Switch off and let it rest for 2 minutes for the motor to cool down before starting again
-
After use, unplug the appliance from the mains. Spin out the jar counterclockwise.
-
Spin the jar lid out
Reminder: turn off the device when blending is complete. Do not run the device
without any food inside the unit as this could overheat the motor.
TIPS
- Cut food into pieces that are no larger than 15 mm cubes for best blending results.
- Do not put any frozen fruit, vegetables, or ice into the unit.
- Portable jar cover: put the juice into the jar, screw the cover into the jar and open the upper cover to drink directly from the jar.
CLEANING
- Put into the blender jar the proper amount of warm water and a little food detergent, cover the jar, and run the machine for about 10 seconds; or soak the mug and blade holder in the water to wash with a brush. Then use the clean water to rinse several times.
- Wipe the main body with a piece of dry cloth. Do not wash it in water to prevent damage.
WARNING: Handle the blade with care – it is very sharp.
Note:
- Don’t use an abrasive cloth or abrasive liquids.
- Do not rinse the device base or submerge the base in water.
- Dry it before reusing it.
- Never use strong household cleaners, ammonia, or abrasives while cleaning the device.
- Cleaning the device immediately after each use will also help to reduce stains.
TROUBLESHOOTING
- Speed: 20000 rpm
- Jar capacity: 2x 500ml
- Stainless steel housing
- Power: 300 W
- BPA-free Tritan jar housing
- Power supply: 220~240 V; 50/60 Hz
Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
Applicable in the European Union and other European countries with separate
collection systems) This marking shown on the product or Its literature
indicates that It should not be disposed of with other household wastes at the
end of its working life. To prevent possible harm lo the environment or human
health from uncontrolled waste disposal, please separate this from other types
of waste and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where
they purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract This product should not be mixed with
other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400
Miętne.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>