teesa TSA0166 Insect Killer UV Lamp Owner’s Manual
- June 5, 2024
- teesa
Table of Contents
teesa TSA0166 Insect Killer UV Lamp
Thank you for purchasing TEESA appliance. Read this instruction manual and keep it for future reference. Producer does not take responsibility for damages caused by inappropriate handling and use of the product.
SAFETY INSTRUCTIONS
In order to reduce the risk of injuries or damages, follow basic safety precautions applied when using any electrical device, including the following:
- Read the entire instruction manual before you start installation and assembly and keep it for future reference. Keep the manual for future reference.
- Before connecting the device to power supply socket, make sure the voltage indicated on the device corresponds to the voltage in the power supply socket.
- Device for indoor use only.
- Do not move the appliance while it is operating.
- Clean this device in accordance to instructions listed in Cleaning and maintenance paragraph.
- ALWAYS turn off the device and disconnect it from the mains supply:
- if it’s not operating correctly
- if there’s an uncommon voice when using
- before disassembling the device
- before cleaning
- when not in use
- When you disconnect the power cord of the device, grasp and pull the plug, not the cord/cable.
- Keep the device out of the reach of children. Do not leave children unsupervised with the product.
- This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised and guided by a person who is responsible for their safety in a cautious manner for all the safety precautions being understood and followed. Children should be supervised to ensure that they do not play with the appliance. Children should not perform cleaning and servicing of the device unsupervised.
- Fixed power cable may only be replaced in an authorized service point.
- Keep the device and its cord/cable away from heat, water, moisture, sharp edges and any other factor which may damage the appliance or its cord.
- The device should not be used in dusty places.
- Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
- Do not use the product for purposes different from displayed in this operating manual.
- Producer of this product is not responsible for damages caused by inappropriate handling and using of the device.
- DO NOT use this device if the cord or the plug is damaged, or the appliance is broken.
- Do not attempt to repair this device yourself. Only authorized and qualified personnel may repair this device.
- Do not touch the live grid and do not put any objects inside the device – there is a risk of electric shock.
- Do not clean the appliance with water.
- Do not use this device near flammables and explosives.
Fluorescent lamp replacement
- Turn off and disconnect the device from power outlet
- Wait about 10 minutes for the fluorescent lamp and the safety net to cool down.
- Unscrew the two screws at the top of the rear safety net (there is an electric grid in the front of the device behind the safety net).
- Open safety net.
- Turn the fluorescent lamp in any direction until the electrodes of the fluorescent lamp are visible in the cutout on the socket.
- Pull out the fluorescent lamp by pulling it towards the cutout on the socket.
- A new fluorescent lamp should be inserted into the socket cutouts and turned by 90° in any direction. Only lamps specified in the specification should be installed.
- Screw the safety net.
CLEANING AND MAINTENANCE
- Before cleaning the device, disconnect it from power.
- Clean the housing with soft, dry cloth. Clean the electric grid with plastic brush.
- The device used should be cleaned at least once a week.
SPECIFICATION
BASIC FEATURES
- Solid housing
- Removable insect tray
- Possibility of placing or hanging
TECHNICAL DATA
- Material: ABS, aluminium, metal
- Lamp: UV-A T8 with diameter 26 mm, G13 base Power of fluorescent lamps: 2 x 15 W
- Lamp lifespan: up to 5000 h
- Range: 100 m2
- Max. power: 39 W
- Shock voltage: 2000-2500 V
- Power cable lenght: 75 cm
- Power supply: 220-240 V ~ 50/60 Hz
PHYSICAL PARAMETERS
- Dimensions: 486 x 72 x 264 mm
- Weight: 2390 g
IN SET
Chain for hanging, users manual
Correct Disposal of This Product
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal. Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>