HOERMANN Garage overhead door User Guide

June 5, 2024
HOERMANN

User GuideHOERMANN Garage overhead door Instructions for fitting, operating, and maintenance
Garage overhead door

Dissemination, as well as duplication of this document and the use and communication of its content, are prohibited unless explicitly permitted. Noncompliance will result in damage compensation obligations. All rights are reserved in the event of patent, utility model, or design model registration. Subject to changes.

About these instructions

Make sure that these instructions remain with the door operator!
Read and follow these instructions carefully!
These instructions are original operating instructions as outlined in the EC Directive 2006/42/EC.
They provide you with important information on the safe fitting and operation, as well as proper care and maintenance, of your garage door.
Keep these instructions and the warranty booklet in a safe place for later reference. Enter the serial number (see the data label) here. Serial no.:
The following documents for safe handling and maintenance of the door system must be placed at the disposal of the end user:

  • These instructions
  • Instructions for the operator
  • The enclosed log book

1 .1 Warnings and symbols used
Special safety information is provided at respective important points in these instructions. They are identified by the following symbols and signal words.

The general warning symbol indicates a danger that can lead to injury or death.

DANGER
Indicates a danger that immediately leads to death or serious injuries.
WARNING
Indicates a danger that can lead to death or serious injuries.
CAUTION
Indicates a danger that can lead to minor or moderate injuries.
ATTENTION
Indicates a danger that can lead to damage or destruction of the product.
| Fitting behind the opening
---|---
| Fitting in the opening
| Fitting in the opening – Flush-fitting with fascia frame 95
| Important note for avoiding damage to property
| High exertion of force
| Tighten the screws by hand
| Move component slowly
| Permissible arrangement or activity
| Non-permissible arrangement or activity
| Read instructions  See the text section (e.g. Section 2.2.1)
| See illustrated section (e.g. Figure 2.1)
| See separate fitting instructions for the control or for the additional electrical control elements
| Risk of impact
| Optional components
| Check for smooth running
| Check
| Dispose of component/packaging

1 .2 Abbreviations used
LB clear width
LMB Structural opening width

**** Safety instructions

ATTENTION:
IMPORTANT SAFETY INSTRUCTIONS.
FOR THE SAFETY OF PERSONS, IT IS IMPORTANT
TO COMPLY WITH THE FOLLOWING INSTRUCTIONS. THESE INSTRUCTIONS MUST BE KEPT.
The manufacturer is not liable for damage resulting from non-compliance with these instructions including the safety instructions
2 .1 Qualified persons
Have a qualified person (competent person in acc. with EN 12635) fit, start up and maintain the door following these instructions. While doing so, observe the requirements in the standards EN 12604 and EN 12635.

2 .2 Intended use

  • The garage door is only intended for private use. If you would like to use the door in a commercial application, first check whether the currently valid national and international regulations permit such use.
  • The garage door is suitable for use outside; it opens and closes vertically.

2 .3 General safety instructions

  • Always keep the door’s area of travel clear. When operating the door, always make sure that there are no persons, especially children, or objects within the door’s area of travel!
  • Never use the door to lift objects and/or persons.
  • Do not alter or remove any components! You could otherwise risk putting important safety components out of action. Only use original parts intended for use with this particular garage door.
  • Protect the door from caustic, aggressive substances, e.g. nitrous reactions from stones or mortar, acids, alkali solutions, de-icing salt, aggressive paints, or sealants.
  • Make sure that there is sufficient water run-off and ventilation (drying) in the lower section of the side guides.
  • Operation of the door during heavy winds may be dangerous.

Fitting and initial start-up

ATTENTION:
IMPORTANT INSTRUCTIONS FOR SAFE INSTALLATION. OBSERVE ALL INSTRUCTIONS AND INCORRECT FIT-
TING COULD RESULT IN SERIOUS INJURY.

3 .1 Safety instruction

WARNING

Danger of injury
There is a danger of injury during fitting. Observe the following instructions:
▶ Wear safety glasses and protective gloves.
** ▶ Check that the fixing materials supplied are suitable for the given structural conditions. Only use suitable fixing material.
▶ Secure the door from falling
ATTENTION**

Damage to the product
Observe the following instructions:
▶ Throughout fitting, protect the door’s components, especially the door curtain, from dirt and damage.
▶ Fasten the side guides with 3 screws on each side. Otherwise, the wind load indicated on the data label is not ensured
| DANGER
Electrical connection / mains voltage
---|---
Contact with the mains voltage presents the danger of a deadly electric shock.
For that reason, observe the following warnings under all circumstances:
▶ Electrical connections may only be made by a qualified electrician.
▶ The on-site electrical installation must conform to the applicable protective regulations (230 / 240 V AC, 50 / 60 Hz).
▶ Disconnect the mains plug before any work on the operator or switch the system off at the mains in case of a permanent installation, and  protect against being switched back on without authorization according to the safety regulations

3 .2 Fitting
The garage door can be fitted from the inside behind the opening or in the opening.
3 .2 .1 Without fitting holes
The door was ordered without fitting holes, so the fitting holes must be drilled at the construction site.
3 .2 .2 Fitting to the ceiling

CAUTION

Protruding anchor
There is a risk of injury when fitting to the ceiling without sufficient headroom.
▶ Shorten the anchor flush with the lower edge of the track

To ensure simple and safe fitting, carefully go through the work steps!
All dimensions in the illustrated section are in mm.
3.3 Initial start-up
Perform a test run and check the door in accordance with Section Inspection and maintenance.
When properly fitted and inspected, the garage door moves smoothly, is functionally safe, and easy to operate.

Inspection and maintenance

4 .1 Safety instructions
▶ Have a specialist perform inspection and maintenance work on the door at least once per year in accordance with these instructions

WARNING

Door travel
There is a danger of injury in the door’s area of travel.
▶ When in operation, make sure that neither persons, children in particular, nor objects are located within the door’s area of travel.
▶ Switch off the operator at the mains. Safeguard the door system against being switched on again without authorization according to the safety regulations.
▶ Functional parts, particularly safety components, may only be exchanged by a specialist

4 .2 Checking the condition of the door
▶ Visually inspect the general condition of the door, all components, and safety devices for completeness, proper condition, and effectiveness.
▶ Check that all of the fixing points are tight. Tighten the screws if necessary.
4 .3 Replace pull cord
▶ Have a specialist replace the high-strength textile cord after max. 10 years!
4 .4 Adjusting the door spring tension
▶ Only have a specialist adjust the door spring tension in accordance with Figure 12.
4 .5 Accessories
To ensure a high level of quality, safety, reliability, as well as long service life, only use original parts intended for this particular garage door.

Cleaning and care

5 .1 Door curtain
▶ Clean the door surfaces with clear water, a soft sponge, and a neutral, non- abrasive cleaning agent.
5 .2 Data label
▶ Clean the data label.
It must always be easy to read

Assistance with malfunctions

If the door is difficult to move or exhibits other malfunctions:
▶ Check all the functional parts. To do this, please follow the instructions in Section Inspection and maintenance.
▶ In the case of uncertainty, please contact a specialist for assistance.

Dismantling and disposal

Have the door dismantled and disposed of by a specialist

HOERMANN Garage overhead door - fig6HOERMANN
Garage overhead door - fig7HOERMANN Garage overhead door -
fig8HOERMANN Garage overhead door -
fig9HOERMANN Garage overhead door -
fig10HOERMANN Garage overhead door -
fig11HOERMANN Garage overhead door -
fig12HOERMANN Garage overhead door -
fig13HOERMANN Garage overhead door -
fig14HOERMANN Garage overhead door -
fig15HOERMANN Garage overhead door -
fig116HOERMANN Garage overhead door -
fig17HOERMANN Garage overhead door -
fig18HOERMANN Garage overhead door -
fig19HOERMANN Garage overhead door -
fig20HOERMANN Garage overhead door -
fig21HOERMANN Garage overhead door -
fig22HOERMANN Garage overhead door -
fig23HOERMANN Garage overhead door -
fig24HOERMANN Garage overhead door - bar
code

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals