ansult 013291 Cord Lamp Instruction Manual
- June 5, 2024
- ansult
Table of Contents
ansult 013291 Cord Lamp
SAFETY INSTRUCTIONS
- The light must be connected to an earthed power point.
- A damaged cord or plug must be replaced by an authorized service centre or qualified personnel to ensure safe use.
- Regularly check all electrical connections and power cords for damage. Rectify any faults before using the light. Always have the wiring and connections checked by an authorized electrician.
- Check that the mains voltage corresponds to the rated voltage on the type plate.
- Do not use the light in explosive environments, such as in the vicinity of flammable liquids, gases or dust.
- Do not use the light in the vicinity of flammable materials.
- Do not look directly into the light source.
- Do not use the light if the glass front is cracked or damaged. Replace a damaged glass front immediately.
- Note the minimum distance between the light and an illuminated object.
- Do not use light sources with more than the permitted output.
- The light source gets hot when the product is switched on. Allow the light source to cool before replacing.
SYMBOLS
TECHNICAL DATA
- Rated voltage 230 V ~ 50 Hz
- Output Max60W
- Socket E27
- Safety class II
- Protection rating IP20
USE
Put the lamp in the required place. Note the minimum distance between the lamp and an illuminated object:
MAINTENANCE
NOTE: Risk of burn injury. The light source gets hot when the product is switched on. Allow the light source to cool before replacing or cleaning.
CLEANING
- Do not use sharp or abrasive utensils or strong detergents.
- Do not use detergent.
- Wipe the product with a dry or damp cloth.
REPLACING THE LIGHT SOURCE
- Unscrew the screw holding the lid in place. FIG. 1
- Lift off the lid glass front. FIG. 2
- Unscrew the old light source and replace with it a new one. FIG. 3
- Replace the glass front and lid.
- Fasten the lid with the screw. FIG. 4
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>