Zyxel NAP303 Dual-radio Smart Antenna 3×3 Nebula Cloud User Guide

: June 5, 2024
: ZYXEL

Table of Contents

Hardware Installation
Ceiling Mounting
Wall Mounting
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Quick Start Guide
NAP303
802.11ac Dual-Radio Nebula Cloud Managed Access Point

Hardware Installation

Connect to an appropriate power source. You do not need to do this if you are using PoE to provide power to your NAP303 via an 8-pin CAT 5 Ethernet cable.
Connect to a (PoE) switch or router that has Internet access.
Manage Your Device
Go to the ZyXEL Nebula Control Center (NCC) website (http://nebula.zyxel.com). Click Login and you will be redirected to the myZyXEL.com portal page. Create an
myZyXEL.com account and sign in.
Create an organization and a site (network). Use the NAP303’s LAN MAC address and serial number (S/N) to register and assign it to the site.
Configure Your Device – Optional
Follow the steps below when you need to change the NAP303’s VLAN setting or manually set its IP address.
Connect a computer to the NAP303.
From the computer, use the NAP303’s DHCP-assigned LAN IP address to access its built-in web-based conﬁguration tool. You can check the NCC’s AP > Monitor > Access Point screen or the DHCP server for the NAP303’s LAN IP address. Alternatively, disconnect or disable the DHCP server and use the NAP303’s default static LAN IP address (192.168.1.2). Make sure the IP address of your computer is in the range between “192.168.1.3” and “192.168.1.154”. After changing the NAP303 IP address or VLAN setting, make sure the NAP303 is connecting to the Internet and the NCC again.

Ceiling Mounting

Remove a ceiling tile and clip the mounting bracket to the ceiling rail by pulling back on the grid clip (A). Alternatively, drill two holes for wall plugs in the ceiling 82mm apart and screw the bracket onto the ceiling.
After the bracket is attached to the ceiling, line up the arrow next to the OPEN position on the NAP303 (B) with a down arrow on the mounting bracket (C).
Push the NAP303 in and turn it to the right until the arrow next to the LOCK position on the NAP303 (D) lines up with the down arrow on the mounting bracket.

Wall Mounting

Drill two holes for the wall plugs, 112 mm apart.
Place the NAP303 onto the screws.

Warranty Form

ZyXEL Warranty Information
Thank you for purchasing a ZyXEL product! We take great pride in our quality, value, and performance and believe that this product should oﬀer you trouble- free operation throughout its lifetime. If you do experience any problems with your product, please contact ZyXEL Communications Corporation oﬃces worldwide. For further information on our warranty regulations and liability in your country please visit the ZyXEL website: http://www.zyxel.com/warranty.
In certain countries, the seller has to ﬁll out, sign, and stamp the following warranty information in order for the ZyXEL warranty to be valid.
See the Nebula Control Centre (NCC) User’s Guide at www.zyxel.com for more information, including safety warnings and customer support.

EU Importer
ZyXEL Communication A/S
Generatorvej 8D, 2860 Søborg, Denmark.
http://www.zyxel.dk
US Importer
ZyXEL Communications, Inc
1130 North Miller Street Anaheim, CA 92806-2001
http://www.us.zyxel.com

Product model number|
---|---
Product serial number|
Date of purchase|
Seller’s stamp and signature|