caple TBU850/TBU520 Touch Control Built-Under Hood Instruction Manual
- June 5, 2024
- caple
Table of Contents
caple TBU850/TBU520 Touch Control Built-Under Hood
WARNING
-
The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure they do not play with the appliance.
-
The cooking surface and the inferior part of the cooker hood must be at a minimum distance of 65 cm.
-
The extracted air can’t be conveyed through or into a duct used to let out fumes from appliances fed by energy other than electric power (eg. centralized heating, radiators, water-heaters, etc.).
-
To evacuate the air outlet, please comply with the pertaining rules given by competent authorities.
-
Provide the room with an adequate aeration when a cooker hood and appliances fed by energy other than electric power (gas, oil, or coal stoves, etc.) are used simultaneously. The cooker hood, when evacuating the extracted air, could generate a negative pressure in the room which can’t exceed the limit of 0.04 mbar, in order to avoid the suck of exhausts deriving from the heat source. Therefore the room should be provided with air-intakes to allow a constant flow of fresh air.
Please keep this instruction manual for future reference Instruction manual TBU850 / TBU520 3 -
When performing the electrical connections on the appliance, please make sure that the current tap is provided with earth connection and that voltage values correspond to those indicated on the rating label placed inside the appliance itself.
-
Before carrying out any cleaning or maintaining operations, the appliance needs to be removed from the electric grid. If the appliance is not provided with a non-separable flexible cable and plug, or with another device ensuring omni polar disconnections from the grid, with an opening distance between the contacts of at least 3 mm, then such disconnecting devices must be supplied within the fixed installation.
-
If the fixed appliance is endowed with a supply cord and a plug, the appliance has to be put in a place where the plug can be reached easily.
-
The use of materials which can burst into flames should be avoided in close proximity of the appliance. When frying, please pay particular attention to fire risk due to oil grease. Being highly inflammable, fried oil is especially dangerous. Do not use uncovered electric grills. In order to avoid possible fire risk, all instructions for grease-filter cleaning and for removing eventual grease deposits should be strictly followed.
-
This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property.
-
The cooker hood is not intended for outdoor use.
-
It must only be used as a domestic appliance to extract vapors and remove odors from cooking. Any other usage is not supported by the manufacturer and could be dangerous.
-
Where a recirculation cooker hood is fitted above a gas hob, please ensure that there is an adequate supply of fresh air into the room in which it is installed. Please seek the advice of a qualified gas fitter (e.g. Gas Safe in the UK) if necessary.
-
Children under 8 years of age must be kept away from the cooker hood unless they are constantly supervised.
-
Children 8 years and older may only use the cooker hood unsupervised if they have been shown how to use it safely and recognize and understand the consequences of incorrect operation.
-
The electrical safety of this appliance can only be guaranteed when correctly earthed. It is essential that this standard safety requirement is met. If in any doubt please have the electrical installation tested by a qualified electrician.
-
Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. These are a fire hazard and do not guarantee the required safety of the appliance.
-
The cooker hood can get very hot during cooking due to heat rising from the hob.
-
Do not touch the housing or the grease filters until the cooker hood has cooled down.
APPROPRIATE USE:
- This appliance is intended to be used in household and similar applications such as:
- Staff kitchen areas in shops, offices and other working environments.
- Farm Houses.
- By clients in hotels, motels and other residential type environments.
- Bed and breakfast type environments.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice. This appliance is marked according to the
European directive on Waste Electrical and Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and human health, which
could otherwise be caused by inappropriate waste handling of this product. The
symbol on the product indicates that this product may not be treated as
household waste. Instead it shall be handed over to the applicable collection
point for the recycling of electrical and electronic equipment. Disposal must
be carried out in accordance with local environmental regulations for waste
disposal.
For more detailed information about treatment, recovery and recycling of this
product, please contact your local council, your household waste disposal
service or the retailer where you purchased the product.
WARRANTY Your new appliance is covered by warranty. The warranty card is
enclosed – if it is missing, you must provide the following information to
your retailer in order to receive a replacement: date of purchase, model and
serial number. Registration can also be completed online by visiting
www.caple.co.uk.
Ensure you keep your warranty card safe, you may need to show it to Caple
Service together with proof of purchase. If you fail to show your warranty
card you will incur all repair charges.
Spare parts are only available from Caple Service and spare parts authorized
centers.
CE DECLARATIONS OF CONFORMITY
This appliance has been manufactured to the strictest standards and complies
with all applicable legislation, Low Voltage Directive (LVD) and
Electromagnetic Compatibility (EMC).
UKCA DECLARATIONS OF CONFORMITY
This appliance has been manufactured to the strictest standards and complies
with all applicable legislation.
TECHNICAL FICHE
This appliance conforms to all current and applicable energy regulations. To
view the Technical Fiche that supports the energy labelling data, please visit
the product page on our website www.caple.co.uk.
USES
The appliance is already arranged both for re-circulation and ducted
installation.
- In Recirculation mode (Fig.1), the air and fumes conveyed by the appliance are cleaned both by a grease filter and by an active charcoal filter, and put again into circulation through the hole made in the top of the cabinet.
- In ducted mode (Fig.2), fumes are directly conveyed outside, through an evacuation duct connected from the extractor to the outside. Both charcoal filter and air deflector are not necessary in this case.
INSTALLATION
Before installing the appliance, make sure that none of the parts are damaged
in any way. In case of damaged parts, contact your retailer and do not proceed
with installation.
Read all of the following instructions with care before installing the
appliance:
- If venting the hood, use an air outlet pipe of the shortest possible length.
- Limit the number of pipe bends.
- Use a duct of recognized and approved material.
- Avoid any abrupt changes of direction and use a duct with a diameter of 150mm constant over the entire length.
NOTE : For more information on venting, please see our `Extraction & Ventilation guide’ available at www.caple.co.uk
ATTENTION: AT LEAST TWO PEOPLE ARE NEEDED TO PERFORM THE INSTALLATION.
Before installing the appliance, in order not to damage the appliance itself,
the metal grease filter should be removed. Open the glass by rotating it
(Fig.3). Then, remove the grease filters by pushing the special filter handle
and pulling it downwards so to unfasten it from its slot (Fig.4).
-
Make a cut-out in the bottom of the cabinet of the following sizes:
TBU520: 265mm x 498mm
TBU850: 265mm x 835mm
Make sure the cabinet structure and the material used allow you to make this opening without causing any damage, even during the appliance installation -
Prepare the power supply.
-
Create a hole for air evacuation.
-
Remove the fixing screws of the rear steel bar (Fig.5).
-
Rotate the steel bar (including the LED bar) to remove it from its position (Fig.6-7).
Electrically disconnect the the LED Bar
-
Insert the appliance into the hole made in the cabinet and fix it by inserting the screws supplied into the holes (Fig.8).
-
Refit the stainless steel bar, electrically connect the LED bar and refit the grease filter
WARNING:
- Before connecting the flexible exhausting pipe to the motor, make sure the stop valve, which is on the air outlet of the motor, can open and close freely.
The cooker hood should be placed at a minimum distance of 65cm above the hob. It is the manufacturer of the hob who determines the clearance required and the clearance quoted by the hob manufacturer must be followed. In the absence of any instructions supplied with a gas hob the minimum distance between the hob and the hood must be at least 760mm
DUCTED VERSION
- Connect the flange to the air evacuation hole with appropriate ducting.
- Connect the appliance to the electrical mains through the supply cord.
RECIRCULATING VERSION
- Connect the flange with appropriate ducting to convey the air to the top of the cabinet.
- Connect the appliance to the electrical mains through the supply cord.
REAR DUCTED VERSION
- To duct the appliance to the rear, remove the 18 screws from the motor support.
- Take the metal support and motor out (Fig.9).
- Rotate the motor to have the air outlet on the rear side and then fix the screws previously removed (Fig.10)
CONTROL PANEL
- A. Light switch on/off
- B. Reduce speed / OFF motor
- C. Motor speed display
- D. ON motor/increase speed
- E. 10-minute timer
NOTE:
If the electrical power supply to the appliance is cut, allow 15 seconds for
the functions to restore properly. In the meantime, the operation may be
incorrect.
The appliance has an electronic device which allows it to automatically switch
off after 4 hours working from the last operation.
TIMING
-
This product is equipped with intelligent electronics which include a timer device for speed controls when the air capacity exceeds 650m³/h. Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped with a timer device that automatically switches the speed from 4th to 3rd speed, after 5 minutes operation. -
External motor models are equipped with remote motors that, as for internal motor versions, include a timer device that switches down the speed when it exceeds 650 m³/h. (See External Motors Instructions). Remote motors, whose air capacity exceeds 650m³/h at both 4th and 3rd speed, will have the following by default timer control functions: The speed is automatically switched from 4th to 2nd speed, after 6 minutes operation.
-
If the appliance is working at 3rd speed, it is automatically switched to 2nd speed, after 7 minutes operation. Operation speeds can also be changed during operation. The energy consumption of the appliance in standby mode is lower than 0.5W.
CLEANING AND MAINTENANCE
Accurate maintenance guarantees good functioning and long lasting performance.
- Particular care must be made when handling the grease filter panel. It can be removed by pushing its handle toward the back-side of the cooker hood and turning the filter downwards so to unfasten it from its slot (Fig.4). To insert the filter just perform the opposite operation.
- After 30 hours of use, the control panel will signal the saturation of the grease filter by illuminating all the buttons. Press the timer button
- After 30 hours of use, the control panel will signal the saturation of the grease buttons. Press the timer button to reset.
- The grease filter needs cleaning regularly by hand or in the dishwasher, at least depending on use.
- The grease filter needs cleaning regularly by hand or in the dishwasher, at least every two months or more depending
NOTE:
If washing the grease filter in the dishwasher, wash separately to prevent
food filter mesh.
-
When the appliance is used in recirculating mode, the active charcoal filter (Fig.12) needs to be periodically replaced. The charcoal filter can be removed by removing the grease filter
first (Fig.4), and by pulling its special plastic tongue until it is unfastened from its slot. Reinsert the charcoal filter by performing the opposite operation. -
The active charcoal filter will need replacing depending on the use, but at least every six months. To purchase replacement charcoal filters (TBU520: 2 x CAP78CF,
TBU850: 2 x CAP42CF) please visit www.caple.co.uk. -
To clean the appliance itself, tepid water and neutral detergent are recommended, while abrasive products should be avoided. For steel appliances specialized detergents are recommended (please follow the instructions indicated on the product itself to obtain the desired results).
-
The LED lights must be replaced only by a qualified or competent person.
-
If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
REPLACING LED LIGHTING
LIGHT SOURCE ENERGY CLASS
This product contains a light source of energy efficiency class F
The LED light must be replaced by an authorized engineer or similar only. For
more information, please contact Caple service – 0117 938 7420 or
service@caple.co.uk
Unplug the unit from the power supply before starting the process.
- Carefully insert a flat screw driver into the edge of the led light.
- Remove the LED light from its housing.
- Disconnect the connector and change the LED light.
- Implement the steps in reverse order.
- After waiting 5 minutes, plug in the unit
Caple Service
Fourth Way
Avonmouth T: 0117 938 1900
Bristol E: service@caple.co.uk
BS11 8DW www.caple.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>