teesa TSA3231 Supreme Pizza Oven Owner’s Manual

June 5, 2024
teesa

teesa TSA3231 Supreme Pizza Oven

teesa-TSA3231-Supreme-Pizza-Oven

Thank you for purchasing TEESA appliance. Please read this operation instruction carefully before use, and keep it for future use. Distributor does not take responsibility for damages caused by inappropriate handling anduse of the product.

SAFETY INSTRUCTIONS

In order to reduce the injuries or damages, follow basic safety precautions applied when using any electrical device, including the following:

  1. Read the entire instruction manual before you start installation and assembly and keep it for future reference.
  2. Before connecting the device to power supply socket, make sure the voltage indicated on the device corresponds to the voltage in the power supply socket.
  3. This appliance must not be supplied through an external switching device, such as a timer, or connected to a circuit that is regularly switched on and off by the utility. The device must be connected directly to the power outlet.
  4. Appliance for household use only.
  5. Clean and store this device in accordance to instructions listed in Cleaning and storage section.
  6. ALWAYS turn off the device and disconnect it from the mains supply:
    • if it’s not operating correctly
    • if there’s an uncommon voice when using
    • before disassembling the device
    • before cleaning
    • when not in use
  7. When you disconnect the power cord of the device, grasp and pull the plug, not the cord/cable.
  8. This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised and guided by a person who is responsible for their safety in a cautious manner for all the safety precautions being understood and followed. Children should be supervised to ensure that they do not play with the appliance. Children should not perform cleaning and servicing of the device unsupervised.
  9. Keep the device out of the reach of children.
  10. Fixed power cable may only be replaced in an authorized service point.
  11. Keep the device and its cord/cable away from heat, water, moisture, sharp edges and any other factor which may damage the appliance or its cord.
  12. Make sure the power cord does not touch any hot or sharp elements.
  13. Do not use the product for purposes different from displayed in this operating manual.
  14. Do not place the appliance in water or any liquid; nor handle/use it with wet or moist hands.
  15. Do not leave the appliance unattended when it’s working.
  16. DO NOT use this device if the cord or the plug is damaged, or the appliance is broken.
  17. Do not attempt to repair this device yourself. Only authorized and qualified personnel may repair this device. Never disassemble this device.
  18. Use only authorized accessories.

IMPORTANT

  • Use the appliance in place with good ventilation.
  • Do not place the appliance close to inflammable liquids or material.
  • The appliance heats up to high temperature during use. Do not touch it with your hands. Always use gloves, handles and knobs provided.
  • Never place the appliance on an uneven surface, sensitive table tops or close to walls and curtains. Never place it directly on another source of heat or on top of another electrical appliance.
  • Do not twist or wrap the power cord around the appliance as this may cause the insulation to weaken and split, particularly in the location where it enters the unit.
  • Do not place utensils or similar objects on the stone.
  • Use utensils specifically designed for non-stick surfaces to avoid scratching. Never remove the food item with metal kitchen utensils.

PRODUCT DESCRIPTION

  1. Temperature knob
  2. Timer knob
  3. Ready light
  4. Handles
  5. Lid window

OPERATION

  1. Place the appliance on a flat, dry and stable countertop.

  2. Connect the plug of the power cord to a wall socket.

  3. Turn the temperature knob to position 400°. The ready light goes on.
    Note: A small amount of smoke can appear when the oven is heated up for the first time. It is normal and will not influence the result.

  4. Always allow the appliance to preheat for approximately 10 minutes with the upper cover closed before starting use.

  5. Place the pizza peels (included in the set) on a plane surface and sprinkle a rich amount of flour on the peels if you use fresh pizza-dough. This will give the dough a crispy surface and make sure the dough doesn’t stick on the peels. You can also add some flour on the stone just before you place the pizza on the stone, especially if you use fresh dough.

  6. Place the pizza on the peels and then add the filling. Do not use too much filling on the pizza. To prevent the pizza being burned, don’t let the filling get in contact with the heating element.

  7. Open the cover, lift the peels and place the pizza on the preheated stone.
    NOTE: Never add oil on the stone. Place the pizza directly on the untreated stone. The surface of the stone will darken after some time of use, which is normal and will not influence the result.
    WARNING! The stone is very hot. Remember to remove the peels before closing the upper cover. The housing of the appliance will be extremely hot during use. Only touch the plastic handle when opening and closing the cover. Be sure to use oven gloves when handling the appliance.

  8. Set the timer by turning the timer knob to the desired position. The alarm will go off when the time is up. Please note that timer is only used to mention the user that time is over but it cannot disconnect the supply mains. It is for alarm function only.

  9. Since all pizzas require different length of cooking-time depending on thickness of dough and filling, start checking the result of the pizza after a few seconds by carefully opening the upper cover. Continue the cooking until desired result is reached. If the pizza is cooked too fast, reduce the temperature. If the pizza is cooked too slowly, increase the temperature.

  10. When the pizza is ready, use the peels to remove the pizza and let the upper cover stay open for a few minutes until the lamp goes on again. After that a new pizza can be placed on the stone.
    Note: Do not cut the pizza while it is still placed on the stone as this can damage the stone.

  11. Disconnect the appliance from power mains and let it cool down completely. Afterwards, clean it as described in the Cleaning and maintenance section below.

OTHER APPLICATIONS

NOTE! Always make sure that the ready light is on before placing food to be prepared on the stone. If the light has gone out, open the upper cover for about 4 minutes until the light goes on again.

  • FROZEN PIZZA
    Recommended temperature setting: 240°-320°
    Tip: Allow deep-frozen pizza to melt in room temperature for 10-15 minutes before cooking. Follow the instructions given in the above section to prepare pizza. Refer to the package to set proper baking time. Regularly check the results. Continue the cooking until desired result is reached.

  • VACUUM-PACKED BAGUETTES
    Recommended temperature setting: 240°-320°
    Place the baguettes (2-3 pieces) on the stone, keeping a distance between them. Refer to the package to set proper baking time. Regularly check the browning result. When the desired browning result is reached, cover the baguettes with aluminum foil and bake some time more.

REPLACING THE STONE

The stone is available to be bought from the online store www.teesa.pl or www.rebelelectro.com

  1. Open the lid.
  2. Take out the old stone with handles.
  3. Put in the new stone and put the handles down.

CLEANING AND MAINTENANCE

  • Always unplug the appliance from wall socket after use and before cleaning. Never clean the appliance while still connected to power mains.
  • Allow the appliance to cool down completely before cleaning.
  • Never immerse the appliance or its cord into water or other liquid.
  • Clean the stone after each use.
  • Do not let the stone get in contact with water or other liquids while still warm since the stone may crack.
  • Scrape out any leftovers with a spatula or similar tool.
  • Wipe off the stone with a moist cloth when the stone is completely cold.
  • When the housing is completely cold, wipe it off with a damp cloth. Do not use any corrosive cleaning agents.

SPECIFICATION

Main features
Two heating elements
Temperature and time adjustment
Ready light
Heatproof handles
Overheating protection
Window in lid

Technical data

Cooking surface: stone
Temperature: 80°C / 160°C / 240°C / 320°C / 400°C Timer: up to 15 min.
Stone diameter: 32 cm
Maximum power: 1200 W
Power supply: 220 ~ 240 V; 50/60 Hz
In set: two steel peels

Physical parameters

Weight: 5 kg
Dimensions: 350 x 370 x 165 mm
Cord length: 90 cm

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)
(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or its literature, indicates that it should not be disposed with other household wastes at the end of its working life. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400 Miętne.
www.teesa.pl 

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals