RYDEEN CM-MINy5 Universal Miny Backup Camera Owner’s Manual

June 9, 2024
RYDEEN

RYDEEN logo

Universal MINy Backup Camera


Owner’s Manual
Model No.: CM-MINy5

Embedded Type CMOS IV Camera

Specification:
Sensor Super CMOS IV
Resolution 648*488
TV Line  480
Min Illumination <0.3 Lux
Angle 170°
Voltage & Max Current 9~16V, 100mA
Video System NTSC(Color)
Image Mirror Image(default)
Parking Line Parking ON(default)
Body Color Black(B)
Water Proof IP67-IP68
Operation Temp -30°C ~ +70°C
Storage Temp  -40°C ~ +105°C
Compliance Statement FMVSS 111
Product Features:
  1. MINy Camera with Super CMOS IV Sensor
  2. Mirror/ standard Image Selectable
  3. Parking Line ON/OFF Selectable
  4. Wider view angle up to 170 degrees
  5. Waterproof: IP67-IP68 approved
Precautious:
  • Remove Protective lens covering prior to use.
  • Be cautious when mounting camera and wiring near fuel tank.
  • System is designed for +12 volt DC systems only.
Electrical Connection:
Scenario A)Backup Camera configuration Only

RYDEEN CM-MINy5 Universal Miny Backup Camera A1

  1. Reverse trigger input
  2. ACC/ING OUTPUT
  3. Reverse Lamp
  4. White loop disconnected For rear installation(Default) White loop connected: For front installation
  5. Green loop Disconnected: Parking line On (Default) Green connected: Parking line Off
  6. Camera
Scenario B)ACC/IGN Backup Camera Configuration

RYDEEN CM-MINy5 Universal Miny Backup Camera A2

  1. Reverse trigger input
  2. ACC/ING OUTPUT
  3. Reverse Lamp
  4. Camera
Scenario C)Front Camera Configuration

RYDEEN CM-MINy5 Universal Miny Backup Camera A3

  1. Reverse trigger input
  2. ACC/ING OUTPUT
  3. Camera
  4. Connected
  5. Not Connected
Camera Installation Position Options:
  1. The camera can be positioned either on the bottom side of the trunk lid or the face side of the rear trunk lid.
  2. Camera can be mounted using either double sided adhesive tape or by drilling into deck lid with short sheet metal screws.
  3. See Images(1) and (2).
  4. Note: Disassembly of the camera mounting bracket may be necessary depending on mounting.

Image(1)                                    Image(2)

Angle adjustment:
  1. Once camera has been mounted you will need to adjust camera for best results.Secure parking brake, shift vehicle into reverse and adjust camera as noted in images(3) and (4).
  2. Once desired angle is set tighten bolt on camera.

Image(3)                                    Image(4)

Technical Support Contact Info:

If you have other questions about RYDEEN Camera products, please contact your retailer or Technical Support:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals