Hangzhou Sujing Technology Co Ltd 2BFNL-7023 Car Multimedia Player Instruction Manual

Hangzhou Sujing Technology Co Ltd 2BFNL-7023 Car Multimedia Player

INSTRUCTION MANUAL

Preface:

In order to prevent injuries and fires, pis pay attention to the following instructions:
In order to prevent short circuit and so on, do not drop the metal objects in the device.
If there is smoke or peculiar smell the device, pis turn off the power at once.
Pis do not make the device falling or strong collision. In order to prevent device failure, pis observe the following note:
Pis do not install the device in the place of strong sunlight, high temperature, high humidity or dusty. Pis replace the fuse which is the same specification. If you are using different specification of the fuse, may cause failure of the device.
In order to prevent short circuit, pis pull out the power wire when you replace the fuse
In order to be able at any time to deal with road and traffic conditions change, pis lower the volume when driving
Pis do not get the device wet when washing car, this may cause short circuitthen fire or other failure will be caused.

Warning:

1.  Only connect the unit to a DC 12V power supply with negative grounding.

2. Never install the unit where the operation for safety driving is restrained
3. Never use the video display function in the front when driving to prevent the violation of laws regulation and also to reduce the risk of traffic accident except using for rear view video camera.
4. Never expose the unit, amplifier, speakers to moisture or water to prevent electronic sparks or fires.
5. Pis don’t change the fuse in the power cord without professional quidance; improper fuse may cause damage to this using unit or even cause fire.

Installation

The unit installs for security, pis install it refer to the following diagram description:
1. pis make the unit in proper place, connect the unit refer to the diagram, and test it works well or not.

2. Pis wrapped the connection line with insulation tape to ensure complete wiring. after testing well.
3. Pis bend the hook of metal 1, and insert the metal to instrument panel then fixed it.

4. Put the unit into metal hook until it lock.

General Features

7″TFT HD Touch Screen BT/FMTF/USB MPS Rearvien Camera
7 inch digital TFT Touch Screen With TF card Slot, With use 2.0 port 1080P Video Format
Support the Audio playback format of MP3/WMA/WAV/FLAC/OGG/APE.
Support the Video playback format of RM/RMVB/DVD (VOB)/VCD(DAT)/MP1/MP2/DIVX/XVID/MP4/H263/H264/FLV/3GP/SWF/AVI/ASF/MJPEG etc;
MOSFET amplifier: 45watts x 4 max power output.
FM Range: 87.SMHr108 0MHz(Europe) With Remote Control
Power-off with auto-memory store function under radio or

TF/USB mode
Clock Function
Mute Function
BT Function

Bass & Treble,L&R channel stabilizer
Aux In Function
Rearvien camera Function
Video input Function

Basic Operation

1. when use reversing rear view function. reversing video signal from the corresponding port input connection back line,when reversing will automatically switch to reversing visua I state.
2. Audio/ Vedio input(optional)
Connect audio/Vedio lines. press Mode can select AUX-2state.
3. bluetooth function only for the unit with bluetooth

After connecting the mobile the bluetooth symbol turn green means the connection is ok ,when calls come in will enter into the bluetooth interface automatically. press answering the phone,press   hanging up the phone

Wire Diagram

1.Brake Control Wire –
2.Parking Control Wire +
3.Battery +
4. Steering Wheel Control Wire
5. the Headlight Control Wire
6. Antenna Control Wire
7. Battery –
8. ACC + 12V
9. Rear Right Horn +
10. Rear Right Horn –
11. Front Right Horn +
12. Fronl Right Horn –
13. Front Left Horn+
14. Front Left Horn –
15. Rear Left Horn+
16. Rear Left Horn

Pis chec( the spea(er line carefully before installation.

IF any grounding or touching, pconnection again or the unit will be burned.

Specification

S R ……………………… , .. , .. , ………………………………….. 6 5d B
Freque n response ………………………………………… 20Hz- 20KHz
Loudspea er ·1mpendc1nce ……………………………….. 49-89
The ma}imum output power ……………………………. 41145W
Tone Contra I …………………………………………………… Bass+/-7dBI lOOHzJ

FM
………………………… Treble+/-7dBf lOOHzJ
FM frequency …………………………………………………. 87.5MHz-108MHz
Se nsitivity ……………………………………………………… 2 5d B
Selectivity ………………………………………………………. 60d B
Se pa ration ……………………………………………………… 35d B

Remote Control Description

Front Panel

HOME

RADIO:

MUSIC:

MUSIC PLAYER

MP3/MP4/WAV/AMR/WMA/OGG/AAC/MID

PHOTO:

Support rear view camera input

Music

UI INTERFACE DISPLAY

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure statement

The device has been evaluatec to meel general RF exposure requirement. The device can be used in porlable exposure condition without restriction.

Specifications:

• Compliance: Part 15 of the FCC Rules
• Operation Conditions: Must not cause harmful interference, must
  accept any received interference

FAQ (Frequently Asked Questions)

Q: What should I do if I encounter interference with the device?

A: Try adjusting the device’s placement and ensure it is away from potential sources of interference. If the issue persists, contact customer support for further assistance.

Q: Can I make modifications to the device?

A: No, any changes or modifications not approved by the responsible party for compliance could void your authority to operate the equipment.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>