teesa TSA8010 Sonic Toothbrush Owner’s Manual

: June 5, 2024
: teesa

Table of Contents

teesa TSA8010 Sonic Toothbrush
OVERVIEW
SAFETY INSTRUCTIONS
CHARGING
OPERATION
TIMER
MODE
BRUSHING TECHNIQUE
CLEANING
SPECIFICATION
Read User Manual Online (PDF format)
Download This Manual (PDF format)

teesa TSA8010 Sonic Toothbrush

Thank you for purchasing the TEESA appliance. Please read this operation instruction carefully before use, and keep it for future use. The producer does not take responsibility for damages caused by inappropriate handling and use of the product.

OVERVIEW

Brush head
Toothbrush handle
Power button (on/off/mode selection)
Normal working mode indicator
Soft working mode indicator
Massage working mode indicator
Charging indicator
Charger unit
Cable

SAFETY INSTRUCTIONS

In order to reduce the risk of any injury, follow basic safety precautions applied when using any electrical device, including the following:

Read this instruction manual carefully, even if you are familiar with the appliance.
Before connecting the device to the power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
ALWAYS turn off the device and disconnect it from the mains supply:
if it’s not operating correctly
if there’s an uncommon voice when using
before disassembling the device
before cleaning
before servicing
When you disconnect the power cord, grasp and pull the plug, not the cord/cable.
This appliance may be used by children who are above 8 years old and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed. Children should not play with this device. Children should not perform cleaning and servicing of the device unsupervised.
Fixed power cable may only be replaced in an authorized service point.
Do not use this appliance if it’s not operating properly or has been dropped into water. Do not attempt to repair this appliance yourself, only authorized and qualified personnel may repair this device. This product has no user-serviceable parts. In case of damage, contact an authorized service point for a check-up/repair.
Keep the device and its cord/cable away from heat, water, moisture, sharp edges, and any other factor which may damage the appliance or its cord.
Do not use the product for purposes/uses different from what is displayed in this operating manual.
The producer of this product is not responsible for damages caused by inappropriate handling and use of the device.
Use only original/authorized accessories.
DO NOT USE while bathing!
Do not place or store product where it can fall or be pulled onto a tub or sink.
Do not reach for a product that has fallen into the water. Unplug from the power supply socket immediately.
Do not handle the plug or the appliance with wet hands.
Product for household use only. Not for commercial use.

NOTE: This device has a waterproof handle. It is electrically safe and is designed for use in the bathroom. But it’s not meant to be used underneath the water.

CHARGING

Make sure the battery is fully charged before first use.
Plug the charging unit into a power supply socket and put the toothbrush handle onto the charging unit, the charging indicator will lit up.
A full charge takes about 24 hours and enables approximately up to 6 weeks of brushing. Once fully charged, the charging indicator turns off automatically.
Pull the charger unit plug out of the power supply socket to save energy, or leave it in and keep the brush on the charging unit (there is no risk of overcharging of battery).

OPERATION

Once the battery is fully charged, attach a brush head to the handle and apply a toothbrush.
Note: there will be about 0,5 mm space between the brush head and the handle.
To avoid splashing, guide the brush-head to your teeth before switching the appliance on.
Place the bristles against the teeth at a slight angle towards the gum line.
Press the power button to turn it on. If you keep pressing the power button, the device will enter the next mode (the sequence is: power on in normal mode, soft mode, massage mode, power off).

Please note: this toothbrush has a memory function; it powers on in the last selected source. However, when powered on for the first time, by default it boots in normal mode. Later on, the device boots in mode it has been used lately.

TIMER

This device has been equipped with 2 minutes auto switch-off function. This feature helps the user to maintain proper oral health care habits. Once the 2 minutes are up, the toothbrush turns off automatically.
The toothbrush stops shortly every 30 seconds to remind the user of the passing time.

Tip: Use this feature to measure equal time for each tooth quadrant. This way you’ll spend 30 seconds on each part.

MODE

This device offers different brushing modes for varying oral care needs:

Normal – Exceptional teeth cleaning; up to 31 000 strokes/minute
Soft – Gentle, yet thorough cleaning for sensitive areas; up to 31 000 strokes/minute
Massage – Gentle stimulation of gums; up to 31 000 strokes/minute

To turn the toothbrush on, press the power button once. If you keep pressing the power button, the device will enter the next mode. The sequence is:

power on in the normal mode
soft mode
massage mode
power off

Please note, you will only be able to change mode within 5 seconds from the last time you pressed the button. Once the 5 seconds are up, the device stays in the chosen mode. Please note, the device enters Normal mode automatically when powered on for the first time. According to the selected work mode, one of the mode indicators will stay lit.

BRUSHING TECHNIQUE

Guide the brush head slowly from tooth to tooth.
Hold the brush head in place for a few seconds before moving on to the next tooth.
Brush the gums as well as the teeth. Start with the outside of the teeth, then the insides, ending with the chewing surfaces.
Do not scrub or press hard, simply let the brush do all the work.

CLEANING

After brushing, rinse your brush head thoroughly under running water.
Remove the brush head from the handle and clean both parts separately under running water. Then wipe them dry before you put the handle onto the charging unit.
Before cleaning your charging unit, make sure you unplug the adaptor. Only use a dry or damp-dry cloth to wipe the surface of the charging unit.

Important: Do not clean the charging unit by immersing it under running or still water.

Place the charging unit in a dry and safe place.
Do not plug in the charging unit it is completely dry.

SPECIFICATION

3 work modes: Normal / Soft / Massage
31 000 strokes/min. (each mode)
IPX7
2 min. auto-off, 30 sec. timer
Medium bristles
2 brush heads in set
Noise level: ≤ 65 dB
Inductive charger
Usage on one charge: up to 6 weeks or up to 180 min. of continuous use
Battery: 700 mAh
Power supply: 100-240 V; 50/60 Hz

Correct Disposal of This Product
(Waste Electrical & Electronic Equipment)

(Applicable in the European Union and other European countries with separate collection systems) This marking shown on the product or Its literature indicates that It should not be disposed of with other household wastes at the end of its working life. To prevent possible harm lo the environment or human health from uncontrolled waste disposal, please separate this from other types of waste and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract This product should not be mixed with other commercial wastes for disposal.

Made in China for Lechpol Electronics