teesa TSA0522 Hair Clipper Owner’s Manual
- June 5, 2024
- teesa
Table of Contents
teesa TSA0522 Hair Clipper
PARTS OVERVIEW
- Blade
- Cutting length switch with button
- Power switch
- Charging indicator
- Power socket
SAFETY INSTRUCTIONS
In order to reduce the risk of any injury, follow basic safety precautions applied when using any electrical device, including the following
- Before connecting the device to power supply socket, make sure the voltage indicated on the appliance corresponds to the voltage in the power supply socket.
- ALWAYS turn off the device and disconnect it from the mains supplyif it’s not operating correctly
- If there’s an uncommon voice when using, before disassembling the device, before cleaning, before servicing.
- When you disconnect the power cord, grasp and pull the plug, not the cord/cable.
- This appliance may be used by children and by persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they are supervised and guided by a person who is responsible for their safety in a cautious manner, and all the safety precautions are understood and followed.
- Children should not play with this device.
- Use only the included AC charger to charge the device.
- Do not use this appliance if it’s not operating properly or has been dropped into water.
- Do not attempt to repair this appliance yourself, only authorized and qualified personnel may repair this device.
- This product has no user serviceable parts.
- Keep the device and its cord/cable away from heat, water, moisture, sharp edges and any other factor which may damage the appliance or its cord.
- Do not use the product for purposes/uses different from what displayed in this operating manual.
- Producer of this product is not responsible for damages caused by inappropriate handling and using of the device.
- Use only original/authorized accessories.
- Do not use the appliance in bath or shower.
- Do not place or store product where it can fall or be pulled onto a tub or sink.
- Do not reach for a product that has fallen into water.
- Unplug it from power supply socket immediately.
- Do not handle the appliance with wet hands.
- Do not immerse the appliance in water or any other liquids.
- Product for household use only.
- Not for commercial use.
- Clean and store this appliance in accordance to instructions.
CHARGING
Notes
Make sure the appliance is turned off before connecting it to the power
supply. It takes about 2,5 hour to fully charge the device what provides
about 4 hours of run time.
- Connect one end of the AC adapter to the power supply socket.
- Connect the other end to the appliance’s power socket.
- When the appliance is charging, red LED is on.
- hen the appliance is fully charged, green LED is on.
INSERTING AND REMOVING COMBS
Notes
Make sure that the appliance is turned off when attaching or removing the
combs. The set includes four guides, each of them having different cutting
lengths 3, 6, 9 and 12 mm.
- Choose the desired comb.
- Attach the comb on the back of the blade and slide it downwards until it locks in place.
- Remove the comb from the blade by pushing it upwards.
OPERATION
-
Slide the Power switch upwards to turn on the appliance.
-
Note
If you want to use the appliance with a comb attached, do it before turning on the appliance. -
Keep holding the button of the cutting length switch and simultaneously slide it upwards or downwards to the desired position. Available cutting lengths are 1, 1,3,1,6 and 1,9 mm.
-
Start cutting your hair when cutting hair with a comb attached, make sure the blade stays close to the skin use the appliance without any comb attached for more precise trim for example on the temples.
-
When trimming is finished, turn off the appliance by sliding the Power switch downwards.
-
If the appliance was used with the comb attached, remove and clean the comb and the whole appliance.
CLEANING
General
- Do not immerse the appliance in water.
- Do not clean the blade under running water. Clean it only with the included brush.
- Do not use any abrasives or chemical agents to clean this product.
- Clean only the casing with a soft and slightly damp cloth.
- Clean the appliance after each use. Regular cleaning guarantees better shaving performance.
- Make sure the appliance is turned off and disconnected from power supply.
- Remove the blade by pushing it out of the appliance.
- Use the included brush to clean the blade and the hair chamber.
- Clean the combs using the brush or rinse them under running water.
- Make sure to wipe them dry before refitting.
Note
The blade has to be lubricated from time to time to provide optimal
performance. To do this, place a few drops of included maintenance oil in
places on the blade indicated.
STORAGE
- Before storing the appliance, make sure it is clean, dry and disconnected from the power supply.
- Store the appliance in a dry, cool place, out of the reach of childre.
SPECIFICATION
MAIN FEATURES
- 4 attached combs 3, 6, 9, 12 mm
- Cord and cordless use
- Charging indicator
- Detachable cutter for easy cleaning
TECHNICAL DATA
-
Power: 3 W
-
Cutter width: 45 mm
-
Length settings: 1 mm, 1,3 mm, 1,6 mm, 1,9 mm
-
Run time: up to 4 h
-
Charging time: up to 2,5 h
-
Noise level: 80 dB
-
Battery: 3,7; 2000 mAh
-
Power supply: Input:100 – 240 V; 50/60 Hz
-
Output: 4,8 V; 1 A In set: AC charger, protective cap, cleaning brush, lubricating oil
-
Weight: 243,2 g
-
Dimensions: 45 x 176 x 39,6 mm
Correct Disposal of This Product
Waste Electrical & Electronic Equipment
Applicable in the European Union and other European countries with separate
collection systems) This marking shown on the product or its literature,
indicates that it should not be disposed with other household wastes at the
end of its working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from other types
of wastes and recycle it responsibly to promote the sustainable reuse of
material resources. Household users should contact either the retailer where
they purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product should not be mixed with
other commercial wastes for disposal.
Made in China for Lechpol Electronics Leszek Sp.k., ul. Garwolińska 1, 08-400
Miętne.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>