WREN WDMSV1 Dragonfly Micro Speaker Instructions

WREN WDMSV1 Dragonfly Micro Speaker

CHARGING YOUR SPEAKER

• Power off the speaker before charging. Open the port cover on the side of the speaker and connect the included charging cable. Plug the other end into a USB power source. A red light will turn on while the battery is charging. When the battery is fully charged, the red light will turn off.
• To optimize long-term battery performance, do not use the speaker while charging, and avoid using the speaker in high-temperature environments. Turn off the speaker when not in use.
• A full charge may take up to two hours and should provide up to four hours of playback. You can check the speaker’s battery level by connecting it to a device (such as a phone) and then viewing the list of active connections on that device. See below for instructions on how to connect to a device.

CONNECTING TO YOUR DEVICE

• To connect a device (phone, laptop, tablet, or other) to the speaker, start with the speaker turned off, then long press J to turn it on. A tone will sound, and the speaker will enter pairing mode automatically.
• Turn on wireless pairing on your device and search for the speaker, which will appear as “Wren Dragonfly” on the list of available connections. Select this; when the connection is successful, a tone will sound.
• Note: The speaker will automatically reconnect to the last paired device (if available and within range).

HOW TO USE

• Long-press to turn the speaker on and off. When powering on or off, the speaker will play a sound.
• Press to skip to the next or previous track.
• Hold to increase or decrease the audio volume. You can also control the volume using a connected device.
• Press to play or pause audio.
• Long-press to turn the LED light on or off.
• To answer an incoming call on a connected phone, press . Press again to end the call. Long-press to reject an incoming call.

TWS MODE

• If you have two Dragonfly speakers, you can enable TWS (True Wireless Stereo) mode to sync their output.
• Power on both speakers and place them within range of each other. Quickly press twice on either speaker to enter TWS mode. A tone will sound from both speakers when successful.
• To exit TWS mode, quickly press ) twice on either of the speakers. A different tone will sound when the TWS connection has been broken.

SPECIFICATIONS

• Waterproof/Dustproof Rating: IP67
• Wireless Standard: 5.3
• Wireless Working Range: up to 10 m
• Speaker: 3 3 mm
• Speaker Output: 3 W
• Speaker Frequency: 60 Hz- 18 kHz
• Battery Capacity: 300 mAh
• Battery Input: Micro-USB 5 V ==- 0.5 A
• Battery Charging Time: 1.5 – 2 hours
• Playback Time: 3 – 4 hours

WARNING

• Do not use this device for any purpose other than its intended use.
• Do not use this device if it shows any signs of physical damage.
• Do not attempt to open, disassemble, modify, or repair this device.
  • Do not expose this device to extreme temperatures (below 5° F or over 125° F).
• Do not use soap, solvents, or chemical cleaners to clean this device.
  • Clean only with a soft, dry cloth.
• Do not expose this device to corrosive materials or pH extremes.

DANGER

• Keep this product away from fire.
• Keep this product out of reach of children.
• This device should be disposed of or recycled according to your local regulations.
  Do not dispose of this device in fire, as it may cause an explosion.

ISED compliance statement

This device complies with Innovation, Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:

1. This device may not cause interference; and
2. This device must accept any interference, including interference that may cause undesired operation of the device.

Radiation Exposure Statement
This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 0 cm between the radiator and your body.

FCC compliance statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
  Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Wren Dragonfly Micro Speaker

• Model: WDMSV1
• Firmware Version: Bluetrum AB5368E V5.3
• FCCID: 2A36Z-WDMSV1
• IC: 30327-WDMSV1

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>