PORTOR LIGHTING PT-TRO-24 PT-TRO Series LED Panel Lighting Instruction Manual

June 5, 2024
PORTOR LIGHTING

PT-TRO SERIES
PT-TRO-24 / PT-TRO-2
INSTALLATION

INSTRUCTIONS

GENERAL WIRING DIAGRAM

WARNING

  • TO REDUCE THE RISK OF DEATH, PERSONAL INJURY, OR PROPERTY DAMAGE FROM FIRE, ELECTRIC SHOCK, FALLING PARTS,  UTS/ABRASIONS, AND OTHER HAZARDS READ ALL WARNINGS AND INSTRUCTIONS INCLUDED WITH AND ON THE FIXTURE BOX AND ALL FIXTURES LABELS.
  • BEFORE INSTALLING, SERVICING, OR PERFORMING ROUTINE MAINTENANCE ON THIS EQUIPMENT, FOLLOW THESE GENERAL PRECAUTIONS.
  • COMMERCIAL INSTALLATION, SERVICE, AND MAINTENANCE OF LUMINAIRES SHOULD BE PERFORMED BY A QUALIFIED LICENSED ELECTRICIAN.
  • FOR THE INSTALLATION: IF YOU ARE UNSURE ABOUT THE INSTALLATION OR MAINTENANCE OF THE LUMINAIRES, CONSULT A QUALIFIED LICENSED ELECTRICIAN AND CHECK YOUR LOCAL ELECTRICAL CODE.
  • TO PREVENT WIRING DAMAGE OR ABRASION, DO NOT EXPOSE WIRING TO EDGES OF SHEET METAL OR OTHER SHARP OBJECTS.
  • DO NOT MAKE OR ALTER ANY OPEN HOLES IN AN ENCLOSURE OF WIRING OR ELECTRICAL COMPONENTS DURING KIT INSTALLATION.

WARNING

  •  TURN OFF ELECTRICAL POWER AT FUSE OR CIRCUIT BREAKER BOX BEFORE WIRING FIXTURE TO THE POWER SUPPLY.
  • TURN OFF THE POWER WHEN YOU PERFORM ANY MAINTENANCE.
  • VERIFY THAT THE SUPPLY VOLTAGE IS CORRECT BY COMPARING IT WITH THE LUMINAIRE LABEL INFORMATION.
  • ALL WIRING CONNECTIONS SHOULD BE CAPPED WITH UL-APPROVED WIRE CONNECTORS.

CAUTION

  • AVOID DIRECT EYE EXPOSURE TO THE LIGHT SOURCE WHILE IT IS ON.
  • ACCOUNT FOR SMALL PARTS AND DESTROY PACKING MATERIAL, AS THESE MAY BE HAZARDOUS TO CHILDREN.
  • RISK OF BURN. DISCONNECT POWER AND ALLOW FIXTURE TO COOL BEFORE CHANGING BULB OR HANDLING FIXTURE.

NOTICE

  • GREEN GROUND SCREW PROVIDED IN PROPER LOCATION. DO NOT RELOCATE.
  • MINIMUM 90° SUPPLY CONDUCTORS.
  • SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
  • SUITABLE FOR DRY OR DAMP LOCATIONS.

INSTALLATION

(ALWAYS TURN OFF THE POWER SUPPLY FROM THE MAIN CIRCUIT BREAKER FIRST!)

  1. Bend out the mounting tab 90º on each corner of the fixture.
  2. Use side cutters tools to adjust each tab to a height of the T-grid.
  3. Lay fixture into T-grid.
  4. Bend tabs flush against T-grid in order to clear corners for ceiling tile.
  5. Use a #8×1/4” sheet metal screw to fasten the fixture to T-grid. Use a hanger wire to tie off appropriately in accordance with local building codes (screws and hanger wires not provided).
  6. Make sure all electrical connections are properly connected. Attach the wiring access cover plate.
  • DIP switches are located on the drive box.
  • Select a wattage and color temperature by sliding the switch left or right respectively to the desired value.

Specification subject to change without notice
www.portorlighting.com 

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

PORTOR LIGHTING User Manuals

Related Manuals