Tenda TEG1024D Network 24-Port 10-100-1000 Gigabit Switch Installation Guide
- June 4, 2024
- Tenda
Table of Contents
Tenda TEG1024D Network 24-Port 10-100-1000 Gigabit Switch
The switch must be horizontally mounted for safe use.
Product Overview
CONNECTION
Safety and Emission Statement
CE Mark Warning
This is a Class A product. In a domestic environment, this product may cause
radio interference, in which case the user may be required to take adequate
measures
The mains plug is used as a disconnect device, the disconnect device shall
remain readily operable.
NOTE: (1) The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. (2) To avoid unnecessary radiation interference, it is recommended to use a shielded RJ45 cable
RECYCLING
- This product bears the selective sorting symbol for Waste electrical and electronic equipment (WEEE). This means that this
- the product must be handled pursuant to European directive 2012/19/EU in order to be recycled or dismantled to minimize its impact on the environment.
- User has the choice to give his product to a competent recycling organization or to the retailer when he buys new electrical or electronic equipment.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class
A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
Caution!
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
NOTE : (1) The manufacturer is not responsible for any radio or TV
interference caused by unauthorized modifications to this equipment. (2) To
avoid unnecessary radiation interference, it is recommended to use a shielded
RJ45 cable.
Technical Support
Shenzhen Tenda Technology Co., Ltd. Floor 6-8, Tower E3, No.1001, Zhongshanyuan Road, Nanshan District, Shenzhen, China. 518052
- USA hotline: 1-800-570-5892
- Toll Free :7 x 24 hours
- Canada hotline : 1-888-998-8966
- Toll Free: Mon- Fri 9 am – 6 pm PST
- Hong Kong hotline: 00852-81931998
- Global Hotline : +86 755-2765 7180 (China Time Zone)
- Website: www.tendacn.com
- E-mail : support@tenda.com.cn
Copyright
©2021 Shenzhen Tenda Technology Co., Ltd. All rights reserved.
Tenda is a registered trademark legally held by Shenzhen Tenda Technology Co.,
Ltd. Other brand and product names mentioned herein are trademarks or
registered trademarks of their respective holders. Specifications are subject
to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>