REELY 2391336 Polymorphous Malleable Plastic for DIY Instruction Manual
- June 4, 2024
- REELY
Table of Contents
REELY 2391336 Polymorphous Malleable Plastic for DIY
Operating Instructions
Polymorphous Malleable Plastic for DIY
Item No. 2391336
Intended use
The product is a non-toxic biodegradable thermoplastic polymer that be-comes
malleable when soaked in water >60 °C. The product solidifies at room
temperature and can be remolded if heated again.
Uses include arts and crafts, prototyping, repairs, and various other DIY
projects.
Not for children below 14 years (14+).
- If you use the product for purposes other than those described, the prod-uct may be damaged. Improper use can result in other hazards.
- The product complies with the statutory national and European require-ments. For safety and approval purposes, you must not rebuild and/or modify the product.
- Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operat-ing instructions.
- All company names and product names are trademarks of their respec-tive owners. All rights reserved.
Delivery content
- Product
- Operating instructions
Latest product information
Download the latest product information at
www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Symbols in this document
The symbol warns of hazards that can lead to personal injury. Read the
information carefully.
Safety instructions
Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling in this manual, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
General information
- The product is not a toy. Keep it out of the reach of children and pets.
- Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
- If you have questions which remain unanswered by these operating instructions, contact our technical support service or other technical personnel.
Operating environment
- Protect the appliance from extreme temperatures, and solvents.
- Protect the product from direct sunlight.
Operation
- Consult an expert when in doubt about the safety or use of the product.
Operation
- Boil some water then pour it into a suitable container. Allow to cool to around 60 °C.
- Pour the pellets into the hot water.
- Wait approximately 2 mins until all the pellets have gone clear and formed a clump. The product is now ready to be molded.
- Carefully remove the clump with tongs and wait until it is cool enough to touch without scalding.
- Mold the clump using your hands or tools if needed.
- Allow to cool to room temperature where it will set as a hard plastic again. Speed the process up by submerging in cold water.
Technical data
-
Component
Polycaprolactone (2-Oxepanone, homopolymer) -
Dimensions (W x H x D)
80 x 110 x 60 mm -
Weight
300 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or capture in electronic data processing systems requires prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represents the technical status at the time of printing. Copyright 2021 by Conrad Electronic SE. *2391336_v1_1221_02_dh_mh_en