munchkin MKCA0807 REV1 Touch Free Wipe Warmer Owner’s Manual

munchkin MKCA0807 REV1 Touch Free Wipe Warmer

IMPORTANT SAFEGUARDS

• WARNING: STRANGULATION HAZARD ALWAYS KEEP THE WARMER AND ITS PLUG OUT OF REACH OF SMALL CHILDREN. Do not use extension cords.

This is NOT a toy. Adult use only. This appliance is not intended for use by children or persons with limited physical and mental capabilities unless they have been instructed or supervised on the proper use of this product by a person responsible for their safety.

• Do not let the cord hang over the edge of the table or counter, or touch hot surfaces.
• Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions or has been damaged in any manner.
• Close supervision is necessary when any appliance is used near children.
• Do not tamper with the warmer in any way.
• Do not use in an oxygen-enriched environment or near equipment that stores or emits oxygen.

CAUTION: Electrically operated product.

• The product should be used for intended purposes only – to warm wipes. Do not use a unit to warm any other objects.
• To protect against electrical shock do not immerse the cord, plug, or warmer in water or any other liquid
• HOUSEHOLD USE ONLY, do not use outdoors.
• Do not use the power cord as a handle.
• NEVER PULL ON THE POWER CORD.
• Arrange the power cord to minimize the possibility of accidents.
• Unplug from the wall outlet when not in constant use and before cleaning.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Do not cover with a blanket or any type of insulating material.
• Because of the continuous low levels of heat and moisture associated with the warmer, the unit must be placed on a compatible surface (wood and painted surfaces are not recommended). Munchkin, Inc. makes no warranty that surface discoloration or damage may not occur due to heat or moisture.

SAVE THESE INSTRUCTIONS

FCC WARNING

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which
  the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3(B)/NMB-3(B)

INCLUDED PARTS

WIPE WARMER POWER ADAPTOR

• Lid
• b. Wipe opening
• c. Main cover
• d. Clear body
• e. Cover indent
• f. Motion sensor
• g. Indicator light (motion sensor)
• h. Light touch sensor (interior LED)
• i. Female plug
• j. Male Plug
• k. Power Adaptor

How to Use

CLEANING THE WIPE WARMER
Always unplug the unit and allow it to cool down before cleaning. Remove any wipes and wipe the unit clean with a non-abrasive cloth. Do not immerse the unit or power cord in water as this could create an electrical hazard. In rare cases, wipes may become discolored due to prolonged exposure to heat.

PREPARING THE WIPE WARMER
Place the unit on a flat, stable surface. Connect the male and female plugs, and then plug the power adapter into a standard household 110-120 volt AC outlet. Do not plug into a 220 volt AC outlet. The indicator light will be on when functioning properly and the unit will begin warming. Only use with a Class 2 Adapter. Use the cover indent on the front of the clear body to lift open the main cover.

NOTE: Plugging in the power cord is the only way to turn the wipe warmer on and off.

1. Remove baby wipes from their original package and place them inside. The unit accepts up to 100 wipes (depending on the brand); do not overfill. Both lids should be able to completely close.
2. With the main cover open, push a corner of the top-most wipe through the wipe opening. Then, close the main cover.

USING THE TOUCH-FREE WIPE WARMER
Wave your hand within the effective range of the motion sensor and the lid will open ‘hands-free’.

1. Once the lid is fully opened, pull a wipe through the wipe opening.
2. Once your hand has been removed from the effective range of the motion sensor, the motion sensor indicator light will blink 5 times before closing to reduce moisture loss.

• NOTE: The effective range of the motion sensor is approximately 3 in. (7.62cm) above the main cover. If the wipes become dry, pour up to 1/2 cup of water directly onto the wipes to re-moisten them. To preserve wipes and save energy, unplug the unit if not in use for a prolonged period of time.
• NOTE: The unit is intended to keep wipes warm for comfortable diaper changes. Wipes are not intended to reach a “hot” temperature.

MOTION SENSOR INDICATOR LIGHT CHART

USING THE TASK LIGHT & NIGHTLIGHT

The task light feature is designed to turn ON automatically when you wave your hand within the effective range of the motion sensor. After 15 minutes of non- usage, the task light will perform an auto shut-off. The task light and nightlight feature can also be turned ON/OFF manually. Simply tap the light touch sensor button to turn ON the task light. Tap the light touch sensor button again for the night light. Tap the light touch sensor button a third time to turn OFF the light and complete the cycle.

NOTE: If you turn the light ON manually, the light will stay ON until:

1. A user turns OFF the light manually, or
2. A user activates the motion sensor.

NOTE: If the motion sensor has been activated with the light feature already ON, the task light will shut OFF after 15 minutes of non-usage.

TECHNICAL SPECIFICATIONS

• Product Name: Touch Free Wipe Warmer and Nightlight
• Model: MKCA0807 REV1

Electrical Rating:

• 12VDC, 720mA, 8.64W, Use only with Class 2 power supply

Customer Service

ONE-YEAR LIMITED WARRANTY

Munchkin’s Touch Free Wipe Warmer and Nightlight includes a one-year limited warranty against defects from the date of purchase. In the event of a malfunction or defect during the in-warranty period, Munchkin, Inc. at its option, will replace or repair the product under warranty. Upon receipt of the product and proof of purchase with a valid date of purchase, the defective part will be immediately repaired or replaced and returned to you free of charge (the USA only). Please send the defective unit, proof of purchase, and a description of the problem you have encountered to Munchkin, Inc. 7835 Gloria Avenue Van Nuys, CA 91406, USA

Attn: Touch Free Wipe Warmer and Nightlight Warranty

NOTE: This warranty does not cover misuse, abuse, abnormal wear & tear, negligence, environmental exposure, alteration, or accident. Any alteration or removal of the product date code invalidates all claims against the manufacturer.

CONTACT US
If you have any questions or wish to provide comments about this product, feel free to contact our Customer Satisfaction team at 1-800-344-2229 (M-TH 8:00 am-5:00 pm PST, F 8:00 am-1:00 pm PST) or visit our website at www.munchkin.com.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>