OPTONICA 5730 220V Single Color LED Strip User Manual
- June 4, 2024
- OPTONICA
Table of Contents
OPTONICA 5730 220V Single Color LED Strip
LED STRIP SINGLE COLOR
Check Points:
- Please check the lamp carefully before the installation.
- Ensure the power is off before wiring and installation.
How to Choose a Power Supply
Tips
Please be kindly informed that the total wattage of LED strip lights should
not exceed the max wattage of the adaptor you chose.
- All the Adapters mentioned in this User Guide have only one DC output terminal.
- Thus they can only be used for one single strip light or a strip connected in series.
- To guarantee the lighting uniformity of both the front and the end of the strip light,
- please do not connect the led strip light more than 5m.
- If you want to use several strip lights together, please connect them in parallel and
- choose another adapter with more than one output terminal.
HOW TO INSTALL
STEP 1
If you want cut this strip light, please refer to the detailed instructions of
LED Strip DIY(following).
STEP 2
Tear off the covering of the adhesive back of LED strip light.
Please cut the LED strip through the lines marked on it.
How to connect the LED strip in series
STEP 3
Stick up the adhesive strip onto where you want to use it. 
- Please prepare two or more LED strips, and make sure the total wattage of LED strips should not exceed the max wattage of the adaptor you chose.
- Please prepare another adapter with more than one output terminal. (All the Adapters mentioned in this User Guide have only one DC output terminal)
- Please ensure that all the LED strips you want to be connected in parallel should be equipped with a DOC port.
- If a LED strip is without any DC port, please equip it with the DC cable (included in the packing box). Please also make sure the positive and negative should be connected correctly.
- When all the strips are equipped with a DC port, connect them directly to the adapter for more than one terminal.
STEP 4
Connect the LED strip and adapter with the remote controller box, and then
insert the DC plug of the adapter into the remote controller box. At last,
connect another plug of adapter into the main socket to power it on.
LED Strip DIY
How to cut the LED strip
How to connect LED strip lights in parallel
- Please prepare two or more LED strips, and make sure the total wattage of LED strips should not exceed the max wattage of the adaptor you chose.
- Please prepare a multi-ports adapter. (All the Adapters mentioned in this User Guide have only one DC output terminal)
- Please ensure that all the LED strips be equipped with the remote controller box.
- When all the strips are equipped with the remote controller boxes, connect them into the multi-ports adapter.
- Connect the multi-ports adapter into main sockets to power it on.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>