EUROSPEC CSL1190SSS Handle Lever 19mm On Round Rose Safety Return Instructions
- June 16, 2024
- EUROSPEC
Table of Contents
CSL1190SSS Handle Lever 19mm On Round Rose Safety Return
Instructions
FITTING INSTRUCTIONS
We recommend consulting a professional if you are unfamiliar with installing
hardware fixtures.
Preparation: Prior to considering fixing this set of lever handles you
should ensure that a suitable lock or latching device with an 8mm follower is
installed in your door. We recommend the installation of a sash lock or latch
with bolt through (male/female) screws for secure fitting to the door. (Fig 1)
The door should be accurately drilled at 38mm centres using an 6mm wood bit. The centre hole for the spindle should be drilled with a 20mm wood bit, in preparation for the fitting of the lever handles (Fig 1)
Fitting: Pull off the outer rose cover from the lever handles and slide carefully off the lever ensuring that you do not damage the lever finish in the process (Fig 2) Place rose covers carefully to one side in the safe place to avoid loss or damage. Check against the door to make sure that the length of spindle will fit through the door and locate with the opposite lever . “If fitting levers to doors thicker than 44mm A longer 120mm spindle (ALS1002H) will be required .”
HESO Spindle : Locate the spindle on one lever ensuring the hollow/line part of the spindle is adjacent to the lever grub screw on the handle until you start to feel resistance. (Fig 3) Then slowly continue to tighten the grub screw, you should feel the grub screw break the outer skin of the spindle (Fig3a) then become free again.
Bolt through operation: Insert male bolts through the inner rose and door so that they locate cleanly with female bolt from the other side. Tighten bolts ensuring that the threads do not cross. (Fig 5) Also fit the supplied wood screws to ensure the inner roses are fixed securely to the door.
Note: Both male and female fixing bolts must be used.
Having securely fixed both levers to the door tighten the remaining grub screw
into the spindle. Slide each rose cover carefully over each lever and tighten
up to the face of the door. Test action of levers and adjust if necessary.
FITCB0100 | Revision A
Drawings are not to scale.
+44 1228 511030
Carlisle Brass Ltd, Parkhouse Road, Carlisle, CA3 0JU
[email protected]
www.carlislebrass.com