ROSWELL 862063-BAT-WH Ronda 63 in. Acrylic Flatbottom Soaking Bathtub Instructions
- June 4, 2024
- ROSWELL
Table of Contents
262063-BAT-WH
Vinnova Inc
Freestanding Bath
Maintenance & Instructions
BAT-WH Ronda 63 in. Acrylic Flatbottom Soaking Bathtub
*** Image for installation purpose only
Please retain this manual after installation for future reference and
maintenance
The product must be installed in compliance with relevant Water Bylaws
IMPORTANT:
- Two people are required for installation
- Freestanding bath is not designed to take weight on the rim. Do not sit or stand on the bath rim
TOOLS REQUIRED FOR INSTALLATION
Step 1
Adjust the bath feet until the bath base is 3mm above the floor; This can be
done by turning the feet bars accordingly; Then using a wrench to tighten the
nuts on the bars See figure 1
Feet set at 3mm above the floor
Step 2
Mark the floor with the outline of the bath, at the final installation
position with the marking pencil
Step 3
Carefully tilt the bath on its side and use the flexible connector to connect
the waste outlet to the trap as illustrated in figure 2
Flexible connector installation
* Flexible connector and waste trap are not supplied
Step 4
Position bath on the floor marking as marked on step 2, make sure that
flexible connector is not kinked upward on installation as this will result in
drainage issue
Step 5**
Apply silicone around the base surrounding the bath, see figure 3
*** Do not use within 24 hours to let the silicone fully cure
Cleaning & Maintenance
A) To preserve the polished surface, after using your bath, clean with a soft
cloth and warm soapy water to wash away any body oils or soap residue that
forms a ring tide mark B) Do not use powders, pastes, crème cleaners,
thinners, window cleaning sprays, dry cleaning liquid, etc.
C) Stubborn marks or fine scratches may be polished out with Brasso
D) When colored essential oils are used, the first test is that the color
won’t stain your bath. Always add oils into a bath full of water. Never pour
them into an empty bath RECEIVING YOUR BATH
A) Unpack and check for damage. After receiving your bath, please unpack and
remove all covering, checking whether there is any damage. Repack the bath if
it is not being immediately installed. It will be rejected any claim for
damage if not notified in a timely manner. B) Protect your bath. Before
commencing installation, ensure the bath is completely protected, and leave
the covering in place until the bathroom is complete. Scratches and cracks
incurred during installation are not covered by the warranty
WATER TESTING
A) Water test your bath prior to enclosing to ensure it drains correctly as no
claims for non-draining baths will be valid after enclosing or tiling has been
done
B) Water test overflow pipe and waste to ensure they are not leaking
REPAIRS
Scratches and cigarette burns can be improved with 1200-grade wet and dry
sandpaper and then repolished with Brasso polishing compound. Always polish
scratch in a circular movement
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>