ROSWELL 862063-BAT-GR Freestanding Bath Instruction Manual

June 4, 2024
ROSWELL

ROSWELL 862063-BAT-GR Freestanding Bath

*** Image for installation purpose only

Please retain this manual after installation for future reference and maintance
Product must be installed in compliance with relevant Water Bylaws

IMPORTANT:

  • Two people are requiredforinstallation
  • Freestanding bath is not designed to take weight on the rim. Do not sit or stand on the bath rim

TOOLS REQUIRED FOR INSTALLATION

 Spinit Level

|

Wrench

|

Tape

---|---|---

Marking Pencil

|

Sicilone Gun

Step 1
Adjust the bath feet until the bath base is 3mm above the floor; This can be done by turning the feet bars accordingly;  Then use wrench to tighten the nuts on the barsSee figure 1

Feet set at 3mm abovethe floor

Step 2
Mark the floor with the outline of the bath, at the final installation position with the marking pencil

Step 3
Carefully tilt bath on its side and use flexible connector to connect waste outlet to the trap as illustated on figure2

Flexible connector installation

  • .. Flexible connector and waste trap are not supplied

Step 4
Position bath on the floor marking as marked on step 2, make sure that flexible connector is not kinked upward on installation as this will result in drainage issue

Step 5
Apply silicone around the base surroundingofthe bath, see figure3

*** Do not use within 24 hours to let the silicone fully cure

Cleaning & Maintenance

A) To preserve the polished surface, after using your bath, clean with soft cloth and warm soapy water to wash away any body oils or soap residue that forms a ring tide mark
B) Do not use powders, pastes, creme cleaners, thinners, window cleaning sprays or dry cleaning liquid, etc.
C) Stubborn marks or fine scratches may be polished out with Brasso
D) When coloured essentials oils are used, first test that the colour won’t stain your bath. Always add oils into a bath full of water. Never pour them into a empty bath

RECEIVING YOUR BATH

A) Unpack and check for damage.
After receiving your bath, please unpack and remove all covering, checking whetherthere is any damages. Repack the bath if it is not being immediately installed. It will be rejected any claim for damage if not notified in a timely manner.
B) Protect your bath.
Before commencing installation, ensure the bath is completely protected, leave covering in place until the bathroom is complete, Scratches and cracks incurred during installation are not covered by the warranty

WATER TESTING

A) Water test your bath prior to enclosing to ensure it drains correctly as no claims for non-draining baths will be valid after enclosing or tiling has been done
B) Water test overflow pipe and waste to ensure they are not leaking

REPAIRS

Scratches and cigarette burns can be in proved with 1200 grade wet and dry sand paper then repolished with Brasso polishing compound. Always polish scratch in a circular movement

**[www.vinnovadesign.com](http://www.vinnovadesign.com)**

Documents / Resources

| ROSWELL 862063-BAT-GR Freestanding Bath [pdf] Instruction Manual
862063-BAT-GR Freestanding Bath, 862063-BAT-GR, Freestanding Bath
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals