keron 297595 Verdi Glove User Manual
- June 3, 2024
- keron
Table of Contents
keron 297595 Verdi Glove
As the gloves are adjusted to special purposes, the lengths may deviate from
the requirements of EN 420:2003+A1:2009.
This product contains latex, which could cause allergic reactions.
| ref.no. | size |
|---|---|
| 297595 | 7 / S |
| 297596 | 8 / M |
| 297597 | 9 / L |
| 297598 | 10 / XL |
| 297599 | 11 / XXL |
Category II – Mechanical risks
EU type examination carried out by:
C.T.C. Parc Scientifique Ton Ganier 4 rue Herman Frenkel 69367 Lyon Cedex 07, France Zertifizierungsstelle / Notified body no: 0075
Instructions for use
Results of the EN 388: 2016 mechanical test
- Abrasion resistance: 2 (min 0 / max 4)
- Blade cut resistance (Coupe – Test): 1 (min 0 / max 5)
- Tear resistance: 3 (min 0 / max 4)
- Puncture resistance: 1 (min 0 / max 4)
- Blade cut resistance (TDM): X (min A / max F)
The sign X, instead of a number, means that the glove is not designed for the use covered by the corresponding test. Results exclusively from samples of the inner hand of the glove
Care and Cleaning
The service stages mentioned are based on tests which were carried out exclusively on unused gloves. Transfer of the results on gloves after care treatment is not possible. The manufacturer accepts no liability for changes to the properties. The condition of the gloves should be checked before reuse.
Packaging and storage
This article is supplied in uniform sales packaging made from recyclable cardboard. PE-bags or similar environmentally friendly coverings are the smallest packaging unit. The gloves must be stored correctly, i.e. in boxes in dry rooms. The properties can be altered by influences such as humidity, temperature, and light, as well as natural alterations to the materials over a period of time.
Aging
It is not possible to give an expiry date, as this can be dependent on the degree of wear, use, and the area in which the gloves are used.
General information / Risk assessment
- The glove types named here meet with the requirements of EU-regulation 2016/425, EN420:2003+A1:2009, EN388:2016. While selecting an equipment, user should perform risk analysis based on the intended use and determine the suitability based on product’s test standards and protection levels obtained.
- Laboratory tests offer an aid to selection, however they cannot take the actual workplace conditions into account.
- It is therefore the responsibility of the user and not the manufacturer to test the suitability of a certain glove for the planned area of use. Gloves for general light handling in wet conditions.
- The equipment provides protection against moderate mechanical risks. The maximum wear time depends on the activity being carried out and the person.
- The glove offers no protection against perforation with sharp objects, e.g. injection needles. No gloves should be worn if there is a risk of becoming caught in moving machine parts
Further information and declaration of conformity by:
Albert Kerbl GmbH Felizenzell 9 84428 Buchbach, Germany
www.keron-online.com
Kerbl UK Ltd Lands End Way Oakham, Rutland LE15 6RF, UK
www.kerbl.co.uk
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>