Keron MagneX 538 Glove Instruction Manual

: June 9, 2024
: keron

Table of Contents

Keron MagneX 538 Glove
EU type examination carried out by
Care and Cleaning
Packaging and storage
General information / Risk assessment
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Keron MagneX 538 Glove

Keron MagneX 538 Glove product
As the gloves are adjusted to special purposes, the lengths may deviate from the requirements of
EN ISO 21420:2020.

EU type examination carried out by

Results of the EN388:2016+A1:2018 mechanical test

Abrasion resistance: 4 (min 0 / max 4)
Blade cut resistance (Coupe – Test): 1 (min 0 / max 5)
Tear resistance: 2 (min 0 / max 4)
Puncture resistance: 1 (min 0 / max 4)
Blade cut resistance (TDM): X (min A / max F)

The sign X, instead of a number, means that the glove is not designed for the use covered by the corresponding test. Results exclusively from samples of the inner hand of the glove.

Care and Cleaning

The service stages mentioned are based on tests which were carried out exclusively on unused gloves. Transfer of the results on gloves after care treatment is not possible. The manufacturer accepts no liability for changes to the properties. For donning, check the integrity of the glove and the picked size fits the hand. For doffing, ease the glove of one hand before removing the second glove to reduce the risk of contamination.

Packaging and storage

This article is supplied in uniform sales packaging made from recyclable cardboard. PE-bags or similar environmentally friendly coverings are the smallest packaging unit. The gloves must be stored correctly, i.e. in boxes in dry rooms. The properties can be altered by influences such as humidity, temperature, and light, as well as natural alterations to the materials over a period of time.
Ageing: It is not possible to give an expiry date, as this can be dependent on the degree of wear, use, and the area in which the gloves are used.

General information / Risk assessment

The glove types na-med here meet with the requirements of EU-regulation 2016/425 and is compliant with the above mentioned harmonised/designated standards, EN ISO 21420:2020, EN388:2016+A1:2018. While selecting an equipment, user should perform risk analysis based on the intended use and determine the suitability based on product’s test standards and protection levels obtained. Laboratory tests offer an aid to selection, however they cannot take the actual workplace conditions into account. It is therefore the responsibility of the user and not the manufacturer to test the suitability of a certain glove for the planned area of use. Gloves for general light handling in wet conditions. The equipment provides protection against moderate mechanical risks. The maxi-mum wear time depends on the activity being carried out and the person. The glove offers no protection against perforation with sharp objects, e.g. injection needles. No gloves should be worn if there is a risk of becoming caught in moving machine parts.