BORMANN PRO BLF2150 50W Waterproof Solar Floodlight User Manual

PRO BLF2150 50W Waterproof Solar Floodlight
User Manual

BLF2150 BLF2350 BLF2550 BLF2650
049197 049210
049234 049258

WWW.BORMANNTOOLS.COM 

Parts

1. Solar Panel
2. Aluminium Alloy
3. Tempered glass
4. Ventilation
5. Outlet
6. Remote Control

• The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes signifi cantly affect the performance and safety of the products. The parts described/illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer’s product line with similar features and may not be included in the product you just acquired.

• Please note that our equipment has not been designed for use in commercial, trade, or industrial applications. Our warranty will be voided if the machine is used in commercial, trade, or industrial businesses or for equivalent purposes.

• To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair, or replacement work, including maintenance and special adjustments, must only be carried out by
  technicians of the authorized service department of the manufacturer.

• Always use the product with the supplied equipment. Operation of the product with non-provided equipment may cause malfunctions or even serious injury or death. The manufacturer and the importer
  shall not be liable for injuries and damages resulting from the use of non- conforming equipment

Operation on mode

50W, 100W, 200W, 300W:

• The solar charging time is 5-8 hours, but there are many factors to be considered, such as the location and temperature of the area.
• When discharging, the mode is 100% brightness in the first hour, 80% brightness in the second hour, 60% brightness in the third hour, 50% brightness in the fourth hour, and 30% brightness in the fifth to the sixth hour. It will remain on until dawn when it will go into charging mode.
• Operating time: 3H, 5H , 8H
• Another mode is brightness adjustment mode, which is indicated on the remote control
• For best results, it is recommended to use the automatic mode “AUTO”.
• Usually, when the device is switched on, the automatic mode is selected by default.
• Automatic mode: The brightness of the whole lamp can be adaptively controlled according to the battery’s own power

IMPORTANT SAFETY INFORMATION

• Do not dispose of the battery in fi re. This may result in an explosion.
• Do not expose the light to fi re or intense heat as the battery may explode.
• Do not immerse in water.
• Never look directly into the light or shine it into another person’s eyes
• Consult your local construction guide, if needed, for installing the light fixture in the building.

FIXING INSTRUCTIONS

• The light fixture should be installed on a fl at and stable surface

• Avoid installing the light near an air conditioner, a central heater, or a high-voltage system

• The solar charger board should be set in a sunny area where maximum sunlight can be collected. Typically, the solar board should face a direction (south) where sunlight  can charge the board for at least 3 hours per day (5 hours per day if behind glass)
  It is suggested to charge the light for 24 hours before first use

• Use a wet cloth to periodically (at least once a year) clean the charger board to avoid the reduction of power output due to accumulated dust

INSTALLATION

1. Fix the bracket of the solar panel.
2. Remove the bracket from the lamp body and fi x it.
3. Fix the lamp body to the bracket.
   

REMOTE CONTROL INTRODUCTION

QUICK SETUP PROCEDURE

WARNING

1. Please keep it away from children.
2. For outdoor use only.

Technical Data

Model| Power| Solar Panel| Battery| Luminous Flux| Additional Specifications
BLF2150| 50W| 5V 8W| 3,2V 6Ah| 500 Lm| CRI>80,IP65,65 K, Remote control
BLF2350| 100W| 5V 15W| 3,2V 12Ah| 1000 Lm| CRI>80,1P65,65 K, Remote control
BLF2550| 200W| 5V 20W| 3,2V 20Ah| 2000 Lm| CRI>80,1P65,65 K, Remote control
BLF2650| 300W| 5V 30W| 3,2V 30Ah| 2500 Lm| CRI>80,IP65,65 K, Remote control

Environmental Protection

Protect the environment. Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.
This symbol indicates separate collection for electrical and electronic equipment required under the WEEE Directive (Directive 2012/19/EC) and is effective only within the European Union.

WWW.BORMANNTOOLS.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>