SJCAM SJ6 Pro Dual Screen Action Camera User Manual
- June 3, 2024
- SJCAM
Table of Contents
SJ6 PRO-Dual Screen Action Camera
USER MANUAL
SJ6 Pro Dual Screen Action Camera
Please read this user manual carefully before using the camera for the first time.
OPERATION SAFETY GUIDELINES
- This is a high-precision product. Do not drop.
- Do not expose the camera to strong magnetic fields, such as electric motors, magnets, and machinery that use strong radio waves.
- Your camera may heat up during use or charging, this is normal. If the camera overheats and/or emits smoke, stop using ft Immediately and remove the battery or external power source.
- Always store the camera and accessories in a cool, dry, and dust-free place_ Avoid direct exposure to heat sources, high temperatures, and prolonged exposure to sunlight.
- This camera model Is not waterproof. Never submerge the camera underwater without using a waterproof housing, always check waterproof seals before doing water activities.
- Always charge your camera away from water, moisture, other liquids, or flammable materials. Keep children and pets away from electronic devices that are charging to avoid accidents.
- Always store extra batteries in a compartment away from any sharp metals and moisture to avoid shorting the terminals.
- Make sure not to overcharge your battery, and avoid extended battery charging.
Do not dispose of the camera or the battery in the garbage bin or in the fire. And a local recycling facility near you for this purpose. If you have any questions, please contact customer service, disassembling the device automatically voids your warranty.
Product Introduction
1. Shutter/OK button
2. Status Inclater It
3. Power button
4.12′ front screw
5. Settings button
6. Lens Bezel| 7. Lens
8. Battery door
9. Quarter-Inch tripod hole
10. USD Type-C port
11. Micro SD card slot
12-air LCD main screen
---|---
Accessories List
Specification
Screen: | 2″ HD touch screen (main screen) 1.3″ LCD (front screen) |
---|---|
Lens angle: | 165° |
Battery: | 1000mAh detachable |
WIFI: | 2.4GHz |
Encoding format | H.264 |
Frequency: | SOHC/60Hz |
Video format | MP4/MOV |
Image format | JPG |
Video resolution: | 4K (3840’2160) 60/30fps 2.7K (2704’1520) 60/30fps 1080P |
(19201080) 120/60/3/fps 720P (1280.720) 120/60fps
Image resolution:| 24M(5696’4272) 20M(51203840) 16M(46083456) 12M(4032″3024) BK3264’2448) 5M(2560’1920) Interface:| Type-C Power input| 5V 2A Storage:| Micro SD card, up to 128G Operating temperature:| -10 t —45 IC Product dimension:| 59.41’28mm Languages:| English
Operating system:| Windows7.8xJ0S x Oil 10.8 or later 2
Camera buttons
- Long press the OK button to switch the front and rear screen display In the Video and Photo modes. Short press the OK button once to start I stop reconciling in the Video Mode, and short press once to take photos while in the Photo Mode.
- Long press the power button for 3 seconds to switch it on and off, and short press once to enter the mode section Interface In the Video / Photo mode.
- In the video/photo mode, briefly press the setting button to enter the setting Interface to set the current mode menu and system menu
Remote buttons
- Power button: Turns off the camera
- Shutter Button: Takes a photo
- WiFi button: Turns on / off camera WiF
- Video button: Starts or stops video recording
Note: SJCAM Remote Control is sold separately.
App Download
https://itunes.apple.com/us/app/sjcam-zone/id991679682?mt=8|
http://android.sjcam.com
---|---
Scan the QR code on your mobile phone, or go to the Apple Store /Google
Play and search “SJCAM zone” to download and install the app.
WiFi connection
Swipe downward from the top of the screen, click the WiFi icon to turn on
the camera WiFi, and the WiFi name and password will be displayed on the
screen.
WiFi Name: SJ6PRO_ XXXXXX
WiFi initial password: 12345678
Turn on the WiFi function on your phone, search and connect the camera WiFi.
Open the app, and click “Connect Camera”, a preview screen will appear, and
the connection will be successful.
After the connection is successful, you can take photos, record videos,
settings, and other operations from the app interface.
Operating instructions
-
Micro SD card Installation Prepare your Mkro$D card for first use by formatting It on the computer and then Insert tt into the device according to the icon direction mated next to the device card slot NOTE Only use a MicroSD card from a reputable brand to avoid data corruption and erratic camera operation.
-
Video recording when you power on your device, will Initially go Into Video Mode. Short press the OK button to record the video. Short press again to stop.
NOTE: The camera will remember the last mode used, and will go into that Mode the next time the rt is powered on. -
Taking photos while the camera Is on, swipe from the bottom of the screen to show Mode options (as shown in the figure below) or briefly press the power button to enter the Mode Selection Menu, Click the photo icon to cuter the photo mode. Use the OK button to take photos.
-
Playback
After the camera is turned on, click the playback icon in the lower-left corner of the screen (as shown in the following figure) to enter the playback mode, select the video/photo to be played back, and then press the OK button to browse. -
Car mode
Long press the power button for 3 seconds to start the device, swipe from the bottom of the screen (as shown in the figure below), or short press the power button to enter the Mode Selection Menu and click the Car Mode Icon to enter the Car Mode video recording.
Note 1. If the camera needs to be installed upside down when using Car Mode, you need to turn on rotation in the system settings. 2. Conned the power adapter to the vehicle. After starting the vehicle, the camera will automatically power on and start recording. After turning off the vehicle, the recording will automatically ^^’A-^”‘ ^ earamPle -
Charging
Two charging modes. A. Connect the camera to a phone charger, or plug it into a computer to charge. During charging, the red light at the bottom left of the device will indicate charging and will go out after the device is fully charged. B. Remove the battery and charge it with a special desktop charger (sold separately).
Note: Make sure to only use a 5V output power adapter. -
Recording settings
A. While the camera is on, dick the Settings icon in the lower right corner of the screen (left In the figure below) or short-press the Setting button to enter the recording setting menu, swipe up or down (right in the figure below) to choose which option you like to set, and click to confirm the selection. B.Recording settings menu.
Resolution: 4K (3840*2160) 60/30fps 2.7K (27044’1520) 60/30fps 1080P (1920.1080) 120/60/3erfps 720P (1280°720) 120/6elps
Loop video: off, 1 minute, 2 minutes, 3 minutes, 5 minutes
FOV: wide, medium, and narrow Low Light on, off VVDR: on, off
EIS: on, off Microphone: on, off Volume: 0, 1, 2, 3
Datestamp: off, date, date time Video format MP4, MOV Video Quality: high, middle Acutancen high, middle, low
AWB: automatic, cloudy, daylight, incandescent, fluorescent, snow mode Effect standard, black&white, natural, negative, retro, contrast
EV: -3.0, -2.0, -1.5, -1.0, -05, +0.0, +05, +1.0, +15, +2.0, +3.0
AE Meter center, multi, spot LDC: on, of -
Photo setting A. While the camera Is on, swipe from the bottom of the screen up to switch to the Mode Selection Menu, select the Photo mode (Figure 1. below), then click the Settings Icon on the lower right corner of the screen to enter the Photo settings menu (Figure 2 below), swipe up or down (right in the figure below) to choose which option you like to set, and click to confirm the selection.
B. Photo setting menu
Image Size: 24M(5696’4272) 20M(5120’3840) 16M(4608•3456) 12M(4032’3024) 8M(3264`2448) SW560’11920)
Long exposure: off, 1sec, 2sec, 5sec, 10sec, 20sec, 30sec, 60sec
Delay Timer: off, 3 seconds, 5 seconds, 10 seconds
Image quality: high, middle, low
Acutance: high, middle, low
AWB: automatic, cloudy, daylight, incandescent, fluorescent., snow mode
Effect standard, black&voNte, natural, negative, retro, contrast
ISO: automatic, 100, 200, 400, 800, 1600, 3200
Exposure compersion: -3.0, -2.0, -1.5, -1.0, -05, +0.0, +0.5, +1.0, +15, +2.0, +3.0 AE Meter center, multi, spot
FOV: wide, medium, and narrow
WDR: on, off
LDC: on, off
Date stamp: off, date, date&time -
System settings
While the camera is on, dick the Settings icon In the lower right corner of the screen (left In the figure below) or short-press the Settings button to enter the Setting menu, then dick the Setting icon on the middle left of the screen (right In the figure below) to enter the System Setting menu, slide the screen up and down to select the menu to be set, and dick OK to select B. System setting menu
Language setting: English
Time: h/m/s
Day. yy/mm/dd Format enter, cancel
WMD: on, off
Fast record: on, off
Quick capture: on, off
Power Off: off, 1 minute, 3 minutes, 5 minutes
Beep: on, off
Screen saver: off, 30 seconds, 1 minute, 3 minutes
Frequency: 50Hz, 60Hz
Upside Down: on, off Logo Marie on, off
WIFI: on, off Startup action: last mode, video, video lapse, slow rec, still, photo lapse, burst mode, video+photo, dash cam, underwater
Reset’ yes, no
System information: view the device version information
Product functionalities may change with product upgrades or firmware updates. Please refer to the actual product specifications.
If you need after-sales service, please contact SJCAM customer service
Technical support email: support@sjcam.com
Welcome to SJCAM’s official website www.sjcam.com
Manufacturer. Shenzhen Zhencheng Technology Co., Ltd
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio [requency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/l’V technician for help.
Made by Shenzhen ZhenCheng Technology Co., Ltd.
3/F Building C, NO.2 Read 1, Shangxue IndustrialArea
Bantian, Longgang District, Shenzhen, China
Technical Support Email :support@sjcam.com
Official website ; sjcam.com
Made in Chine
References
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza | Alza.co.uk
- Alza.cz – rychlý a pohodlný nákup odkudkoliv | Alza.cz
- Alza.cz
- alza.de
- alza.hu
- alza.sk
- Best Budget Action Cameras | Body Cameras - SJCAM Official
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>