ROPER RHODES DIODE-SF Duty Soft Close with Quick Release Installation Guide
- June 1, 2024
- ROPER RHODES
Table of Contents
ROPER RHODES DIODE-SF Duty Soft Close with Quick Release
FITTING INSTRUCTIONS
Please read carefully before attempting to fit the seat & refer to the ‘does
it fit’ diagram below to ensure it’s suitable for your toilet.
Please make sure the warnings and after-care instructions are made available
for the end user to read.
Does it fit?
Please can you measure before opening the pack
General seat dimension
Max/min fixing adjustment
Top Fix Installation
Note – alternative nuts and washers are supplied if you wish to secure the seat from underneath the deck of the toilet pan. If so dispose of the black top fix inserts and tighten with the securing key supplied.
Instructions – Fitting on Pan
-
Push top fix inserts into toilet pan holes.
-
Place the template over the anchor pins, selecting the appropriate hole numbers (on the anchors) so that the 435mm dimension from the front of the pan to the centre line of the template is met.
Note: Selected anchor numbers must be matching
-
Once the 435mm dimension shown above is met and the template is parallel to the back edge, insert the bolts then tighten using a screw driver.
Secure as tightly as possible by hand. Do NOT use a battery drill or driver.
-
Remeasure the distance, making sure the 435mm dimension is met and remove the template and add the cover cap.
Click seat in place.
Under Fix Installation
-
Place the template over the anchor pins, selecting the appropriate hole numbers (on the anchors) so that the 438mm dimension from the front of the pan to the centre line of the template is met.
Note: Selected anchor numbers must be matching
-
Once the 438mm dimension shown above is met and the template is parallel to the back edge, insert the bolts and tighten the underfix components, then tighten using a screw driver.
Secure as tightly as possible by hand. Do NOT use a battery drill or driver.
-
Remeasure the distance, making sure the 438mm dimension is met and remove the template and add the cover cap.
-
Click seat in place.
WARNING
- The fittings pack contains small items which should be kept away from young children.
- The toilet seat can be dangerous if incorrectly installed. Assembly should be carried out by a competent person. No liability will be accepted for damage or injury caused by incorrect product installation or assembly.
- Do not stand on the lid or ring of your toilet seat.
- After a few days check that the fixings are still tight. This is necessary as the rubber components will compress during the first few days.
- Periodically check all fixings to ensure none have come loose and re-tighten where necessary. Please take care when handling or moving the toilet seat as careless handling may cause damage or injury.
- Never over rotate the seat open when it is removed from the WC as this can cause damage to the hinges.
- Do not force down the seat ring or lid as this may compromise the performance of the soft close hinges.
AFTERCARE INSTRUCTIONS
Removing seat for cleaning.
Clean surfaces with a soft damp cloth and mild soap solution.
Do not scrub or scour
Do not use abrasive cleaning agents. If using bleach, abrasive or corrosive cleaning agents inside the toilet bowl, ensure that these do not come into contact with the seat. Keep the seat in the upright position until all cleaner has been flushed away.
Do not stand on the lid or ring of your toilet seat.
Customer Support
For technical Help Call:
01225 303 900
Roper Rhodes Ltd | Brassmill Lane Trading Estate | Bath | BA1 3JF
E: sales@roperrhodes.co.uk
W: www.roperrhodes.co.uk
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>