Intellitronix BG10001 Universal 5.5 Gauge Bargraph Dash Panel Installation Guide
- June 3, 2024
- Intellitronix
Table of Contents
Intellitronix BG10001 Universal 5.5 Gauge Bargraph Dash Panel
Thank you for purchasing this instrument panel from Intellitronix. We value our customers!
Always disconnect the battery before attempting any electrical work on your vehicle.
KIT COMPONENTS
- One (1) LED Bargraph Circuit Board with Speedo/Tach combination gauge, plus temperature, fuel, oil pressure, and voltmeter.
- One (1) Smoked Acrylic Lens
- Peel off the protective covering from both sides of each lens
- One (1) Temperature Sending Unit (S8013)
- 1/8” NPT, 0-255 Deg., 1/2” NPT Bushing
- One (1) Pressure Sending Unit (S8434)
- 1/8” NPT, 0-100 PSI Oil Pressure
- One (1) Universal Speedometer Sensor (S9013)
- 7/8” NPT Industry Standard threads
- One (1) Mounting Kit
WIRING INSTRUCTIONS
Note: Automotive circuit connectors are the preferred method of
connecting wires. However, you may solder if you prefer.
Ground – Black This is the main ground for the display system. A wire
should be run from this board to the vehicle’s main engine block ground. Use
18 AWG or larger wire to ensure sufficient grounding. Proper vehicle grounding
is extremely important for any gauges (or electronics) to operate correctly.
The engine block should have heavy ground cables to the battery, frame, and
firewall. Failure to properly ground the engine block, senders, or digital
dash can cause incorrect or erratic operation.
Power – Red Connect the power terminal to accessory +12V power from the fuse panel or vehicle wiring harness. This terminal should have power when the key is on or in the accessory position. Use an 18 AWG wire to ensure the system receives a sufficient power feed. This connection also feeds the voltmeter.
1 – BG10001 Intellitronix (rev. 06/2018) www.intellitronix.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>