Intellitronix B9016 LED Analog Bargraph Fuel Gauge Installation Guide
- June 12, 2024
- Intellitronix
Table of Contents
Intellitronix B9016 LED Analog Bargraph Fuel Gauge Installation Guide
Thank you for purchasing this instrument from Intellitronix. We value our customers!
Always disconnect the battery before attempting any electrical work on your vehicle.
WIRING INSTRUCTIONS
Note: Automotive circuit connectors are the preferred method of connecting wires. However, you may solder if you prefer.
| Model | Resistance | Wire(s) to cut |
|---|---|---|
| Ford/Chrysler | 73 to 10 OHM | NONE |
| GM | 0 to 90 OHM | Blue |
| VDO | 10 to 180 OHM | Blue & Orange |
| Universal | 240 to 33 OHM | Orange |
Ground – Black Connect directly to an engine ground such as the engine block. For the most accurate readings, connect to the same ground that the sending unit is attached to.
Power – Red Connect to a switched +12V source such as the ignition switch.
Note: The device will NOT function properly without a steady +12V source. For best results use a multimeter to test the power source.
Dimmer – Purple Connect to the parking lights to dim the LEDs 50% when the headlights are on. However, do not connect to the headlight rheostat control wire; the dimming feature will not work properly. Otherwise, connect to ground for permanent 100% brightness.
Pressure – Yellow Connect to the output of the sending unit
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>