SwissPlus ID Z1001 BT SmartScan Electronic RFID Reader User Manual
- June 5, 2024
- SwissPlus ID
Table of Contents
SwissPlus ID Z1001 BT SmartScan Electronic RFID Reader
Congratulations! You have just acquired your Z1001 “SmartScan” reader. This reader can read all brands of 9, 10 and 15 digit microchips. All electronic chips (complying with standard ISO 11784/5), FDX-A, FDX-B, FACAVA and AVID encrypted chips. It won’t read the discontinued AKC Trovan chips. As you will be able to see for yourself, it is extremely simple to use.
Description: Z1001 Reader
The reader has an on/off/Bluetooth switch on the right hand side, a mini USB port on the left hand side and a central Press to Read button. It is advised to not remove the Mini USB cover.
Activating the reader
When the reader is switched off, you can switch it on by using the on/off
switch (3). If Bluetooth function is required switch on using the on/off
switch moving it to the Bluetooth position (2).
Note: that the display doesn’t activate until the first chip is read.
This is a power saving measure.
SCAN : Pressing the Read Button (4) activates the display and a chip
search for 20 seconds.
READING : The operator must hold the reader close to the place where the
chip is assumed to be, scanning over the area slowly. Two cases may arise:
First case:
A transponder chip is detected. The reader emits two “beeps” and displays
the identification number in on screen. The number remains displayed until the
Read Button is pressed again or for 15 minutes until the reader switches
itself off.
Second case:
No transponder chip is detected. If no transponder has been detected after 20
seconds, the reader emits a single “beep” and displays: “No ID Found!”
In this case, it is recommended to make two or three or three further attempts
to read a chip, scanning more widely over the area in which it is assumed to
be implanted. Each successive pressing of the Read button (4) will erase the
“No
ID found!” display and restart the reading process.
Note: A series of beeps will alert you every 3 minutes that the unit is
still on. After 15 minutes of no activity the unit will power off.
Bluetooth
Switch to Bluetooth (2) and press the Read Button. Enable Bluetooth on your device and wait for a connection called: CSR HID Keyboard”. Choose and follow your device instructions for pairing. Once paired the Bluetooth icon in display will stop blinking. On your device the number will appear where your cursor is placed.
Battery
When the display indicates “Low Battery” replace battery with an Alkaline 9V battery only.
Certifications:
CE and FCC
Guarantee
90 Days parts and labour with return to factory. Designed in USA and made in Thailand.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>